User manual MIELE S2120

[. . . ] Operating Instructions Vacuum Cleaner S 2000 To prevent accidents and machine damage, read these instructions before installation and use. 28 3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE ~ To reduce the risk of electric shock, WARNINGTo reduce the risk of fire, electric shock or injury: Before Using ~ Check the voltage rating of the vacuum cleaner before connecting the power cord to an electrical outlet. Your power source should correspond with the voltage rating plate located on the underside of the vacuum. If you are not sure of your home's voltage supply, consult a qualified electrician. [. . . ] For cleaning smooth floors, raise the tool by: ^ pressing the foot switch marked ä. 11 Using the included accessories The following accessories are included: a Dust brush with natural bristles b Upholstery tool c Crevice nozzle d Accessory clip for the included accessories Position the accessories as indicated. Accessory clip ^ Press the accessory clip either above the hose connector or below the suction hose. Floor brush The floor brush is suitable for cleaning carpets, rugs, carpeted stairs and hard surfaces that are not susceptible to scratching. For safety, when vacuuming stairs it is best to start at the bottom and move upwards. 12 Operation Power cord , Unwind the cord completely to aid the vacuum in dissipating heat. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. , To reduce the risk of electric shock, the vacuum has a polarized plug (one blade is wider than the other). If the plug does not fit fully in the outlet, contact a qualified electrician. ^ Press the rewind switch - the power cord will rewind automatically b. 13 Operation Turning the vacuum On/Off ^ Press the On/Off foot switch s. , To prevent static electricity your hand must touch the metal inlay on the underside of the vacuum hand piece. Be certain to continuously touch this inlay when vacuuming fine dust, flour or sawdust as these materials are more likely to create a static discharge. To further prevent static discharge, pull the vacuum along by the hose with one hand while continuing to hold the hand piece in the other hand. 14 Operation Adjusting the suction You can adjust the suction power to suit the type of flooring. The symbols on the controls indicate the type of use the settings are suitable for: # curtains, lightweight fabrics $ upholstery, cushions % * ( ) thick pile carpets, rugs and runners energy saving, daily vacuuming with low noise level lightly soiled textured carpets textured hard flooring, and for intensive cleaning of carpets ^ Turn the suction power selector to the desired setting. Opening the air inlet valve The air inlet valve can be opened to quickly reduce the suction power of the tool being used, e. 15 Transport and storage Park-System (unable to be used with the Powerbrush SEB 228 / EB03. ) The Park system allows you to conveniently park the wand and floor brush on the vacuum cleaner during brief pauses. ^ Insert the lower clip on the floor brush into the slot on the end of the vacuum cleaner from above. Transport and storage ^ For easier transportation and storage stand the vacuum cleaner vertically. ^ Insert the parking clip attachment on the floor brush into the parking slot from above (does not apply to Powerbrush SEB 228 / EB03). [. . . ] New thread catcher pads can be purchased from any authorized Miele vacuum dealer or Miele. 22 Cleaning and care , Turn off the vacuum and unplug it from the outlet before performing any maintenance work. Vacuum cleaner and accessories The vacuum cleaner and other plastic accessories can be cleaned with a damp cloth or a cleaner suitable for plastics. Dust compartment The dust compartment can, if necessary, be cleaned using a dry cloth, dusting brush or a second vacuum to remove any dust. [. . . ]