User manual MIELE S2111

[. . . ] Improper use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the vacuum cleaner, please read these instructions carefully before using it for the first time. They contain important information on its safety, operation and maintenance. Keep these instructions in a safe place and ensure new users are familiar with the content. [. . . ] ^ Press the telescopic tube release button to release the tubes and adjust to the required height. 6) a Push the suction tube into the floorhead and turn it clockwise or anti-clockwise until it clicks into position. Removing the floorhead b To release the floorhead from the suction tube, press the release button and pull the suction tube away from the floorhead. Adjusting the floorhead The floorhead can be used for all normal cleaning of carpets and rugs. It can also be used with the brush protruding to vacuum hard flooring. 1) a Insert the hose connector into the socket on the vacuum cleaner until it clicks into position. Removing the suction hose from the cleaner b Press the release buttons at the side of the hose connector and lift the hose from the socket. 2) ^ Fit the hose connector securely into the handle, making sure it clicks into position. Your vacuum cleaner is fitted with one of the following suction tubes, depending on model (see "Description of the appliance"). – EasyLock suction tube – Telescopic suction tube Connecting the EasyLock suction tube sections (dia. 3) ^ Take the section with the connecting piece, insert it into the other section and turn it clockwise or anti-clockwise until it clicks into position. 9) Please observe the flooring manufacturer's cleaning and care instructions. C Vacuum carpets and rugs with the brush retracted (press foot control %). Clean hard flooring which is not susceptible to scratching with the brush protruding (press foot control )). Clean flooring which has deep crevices or grooves with the brush protruding. Warning: For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards. Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Rewinding the cable ^ Switch the vacuum cleaner off at the wall socket and unplug it. 7 + 8) The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d Accessories holder for the three accessories supplied There are symbols on the accessories holder to show you where to postion the accessories. ^ Attach the accessories holder pointing upwards to the hose connector socket or pointing downwards to the suction hose where it joins the handle. [. . . ] Replacing one type of exhaust filter with another Depending on model, your vacuum cleaner can be fitted with an Active Air Clean filter or an Active HEPA filter instead of the standard Air Clean filter. To change the type of filter, the Air Clean filter and the filter grille must first be removed and the new type of filter then fitted instead. When to replace an Active Air Clean filter or an Active HEPA filter These types of filter need to be changed approx. 33 When to change the thread lifters The thread lifters on the suction inlet of the floorhead can be replaced. [. . . ]