User manual MIELE MLT 4801 INSTALLATION MANUAL

[. . . ] 3 - Connect the cooker hood to the mains via a bipolar switch which has 3mm clearance between the contacts. 4 - For cooker hoods featuring an earth cable, make sure the electric plant of your house is correctly earthed. 5 - Appliance in class II are provided with a double insulation; therefore do not connect then through earthed plugs but through simple bipolar plugs. 6 - When installed, the hood must be positioned at least 65cm above the hotplate. [. . . ] 8 - Never leave frying pans unattended during use as overheated fat and oil may catch fire. 9 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 10- If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 12- If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. Before installing the hood it is possible to fit the splashback provided, if required. Fix the splashback to the wall using the two 3x35 screws (provided). The hood can be supplied with two different fixing kits: a) screws, plugs and safety square. 1 - Fixing with screws Using the cardboard template, mark and drill the holes on the wall (2 holes Ø 8 mm see instructions on the template), insert the plugs in the holes, tighten both 4, 2 x 44, 4 screws(supplied) leaving about 5 mm unscrewed, hook the hood onto the screws (fig. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods. Regular maintenance will ensure good performance and extend the working life of the hood. Special attention should be taken to the grease filters and, for the filter hoods only, to the charcoal filters. 1 - Cleaning These filters need to be washed with ordinary household detergent every 2 months maximum. Thanks to their reduced dimensions, they can also be washed in the dishwasher. Make sure that the filter is dry before replacing it, close the grid panel. 1 - How they work Charcoal filters can absorb smells and odours until they are saturated. They cannot be washed or recycled and so they should be replaced at least every 4 months or more frequently if the hood is heavily used. It is composed of one or two 40 W lamps which can be reached by removing the grid panel (Fig. [. . . ] It is composed of one or two 40 W lamps which can be reached by removing the grid panel (Fig. If the lights fail to function, check that they are fully screwed into place. If they have blown, they should be replaced with similar lamps having the same voltage and power. When cleaning the hood: - Never use a wet cloth or sponge, or running water. [. . . ]