User manual MIELE KM391G

[. . . ] Operating Instructions Gas Cooktop KM 391 ® ® To prevent accidents and machine damage, read the Operating Manual before installation or use. UV M. -Nr. 06 073 600 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] ^ When the flame appears, keep the control knob pressed in for 8 - 10 seconds to allow for the Ignition Safety Control to reach operating temperature. 15 Cleaning and care Grates, Control Knobs Do not use a steam cleaner to clean this cooktop. Pressurized steam could cause permanent damage to the surface and its components, for which the manufacturer cannot accept responsibility. Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame or between the frame and the countertop. Never use scouring agents or pads, abrasive cleaning agents or strong cleaners such as oven sprays, stain or rust removers, these could damage the surface of the appliance. After cleaning, the ceramic surface must be thoroughly dried with a soft cloth to prevent a build up of limescale deposits. ^ Let the appliance cool to a safe temperature before removing the grates. ^ Clean the grates and knobs with a sponge and a mild solution of warm water and liquid dish soap. ^ Dry grates and knobs thoroughly after cleaning. Ceramic surface The ceramic surface should be cleaned regularly, preferably after each use. ^ Sugar or syrup spills must be cleaned before the cooktop cools completely or the glass will dimple. ^ Apply a cleaner for ceramic surfaces using a soft cloth or paper towel. ^ Wipe the ceramic surface with a damp cloth and then dry it with a clean soft cloth. 16 Cleaning and care Burner The burner can be dismantled and cleaned when completely cool. Dismantling and cleaning ^ Remove the burner parts and wash them in a solution of warm water and liquid dish soap. ^ Gently wipe the ignitor and Ignition Safety Control with a damp cloth, and then dry with a soft cloth. ^ Place the burner head, b, onto the burner base, a, so that the Ignition Safety Control and ignitor extend through their respective holes. Reassembling Auxiliary, Normal and Fast burner 17 Cleaning and care Reassembling the wok burner Be careful not to mix up the parts. ^ Place the burner head, c, onto the burner base, d, so that the ignitor, e, and the Ignition Safety Control, f, extend through their respective holes in the burner head. ^ Replace the burner cap, a. 18 Frequently asked questions , Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. The manufacturer cannot be held responsible for unauthorized work. The burners do not ignite after several attempts. ­ The burners are wet and soiled and/or the flame holes in the burners are soiled and clogged. ­ The cooktop is not plugged in and the circuit breaker has tripped. Fix ­ Reassemble the burners as shown in "Cleaning and Care - Burners". See "Using the cooktop during a power failure". The flame goes out after being lit. [. . . ] Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing of that system performed in excess of ½ psi (3. 5 kPa). The appliance must be isolated from the gas supply line by closing its individual manual shut off valve at test pressures equal to or less than ½ psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. [. . . ]