User manual MIELE KM 88-2

[. . . ] Be sure your appliance is properly installed and grounded by a qualified technician or electrician. Before servicing, disconnect the power supply by removing the fuse or tripping the circuit breaker. The electrical safety of this appliance can only be guaranteed when continuity is complete between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. [. . . ] See the chart on page 9 for a more detailed description of which setting is recommended for which food. By turning the racks over, it is possible to grill at two different heights. the high rack position for larger items of food which take longer to cook. Turning the grill on The grill will turn on when a setting is selected. As you increase from setting 1-12, the heating element will become progressively hotter and the selected temperature will be automatically controlled. On setting 12, the heating element is at maximum power. After grilling: keeping food hot To turn the grill off: Turn the controls to setting "0". If there is heavy soiling on the heating elements: Turn the controls to setting "12". Should any residue remain, it can be removed with a wire brush once the heating elements have cooled. Grilling and keeping food warm Separate control of the two grilling zones make it possible to grill meat on one area and keep already grilled food hot on the other area. For example, sausages can be grilled and then kept hot. 8 Grilling Grilling Grilling over lava rocks Before cooking, remove the grill racks and raise the heating elements. Take the lava rocks out of their bag and put them into the lava rock tray. We recommend pre-heating the elements at setting "12" for approx. This will allow the food to cook using heat radiated by the lava rocks. If you wish to add herbs to the food while grilling, they can be sprinkled directly onto the meat or onto the lava rocks, so the aroma reaches the food. As the lava rocks absorb the fat which drips onto them, they will eventually become saturated. With a DA 8 extractor situated next to the grill, the smoke can be removed from the atmosphere. Grilling over the water trough Before turning on the heating elements: remove the lava rock tray from the grill. First check that the drain valve underneath the grill is closed, then fill the trough up to the lower rim with approx. We recommend pre-heating the elements at setting "12" for approx. This will allow the food to be cooked by steam, as well as heat from the grill. Drops of fat will be cooled immediately in the water trough, so that they cannot catch fire. When grilling, monitor the level of water in the trough; if necessary, carefully add more water. After grilling, drain out the water and oil through the drain valve (see "Cleaning and Care"). 9 Grilling Grilling Cooking chart for grilling over lava rocks, or over water. Food Fillet Steak (40Z) - On Elements - On Racks Setting 10 10 10 8 10 10 10 10 10 10 8 8 10 9 9 Time in mins* 2 (Rare) 6 (Med. ) 4 (Rare) 10 (Med. ) 14 16 20 22 10 12 20 15 40 15 10 Pork Chop Pork Kebab Lamb Chop Spare Ribs Sausage Burger Mackerel (Whole) Fish Fillet Vegetable Foil Parcels Banana (In Skin) Fruit Kebabs Please Note: The times given are for a pre-heated grill and should serve only as a guide - the actual cooking time will depend on the size and quantity of food being cooked. Times may be a little longer when using the water trough as compared to using the lava rock. * Food should be turned over half way through the cooking time. 10 Cleaning and Care Cleaning and Care Grill racks The grill racks can be washed by hand or in a dishwasher. If, over time, the racks become brown, the residue can be removed with a stainless steel cleaner. [. . . ] DA 8-2) 490 1437 490 1436 490 1729 For building in between two appliances: - Dimension B increases by 90 mm. For building in at the end of a combination: - Dimension B increases by 98 mm. * Width includes provision for V 98 spacer bar. 16 Installation instructions Installation instructions Depth in inch 2 zone Combiset Width * (= Dimension B) in inch 1 Combiset 2 Combisets 3 Combisets 4 Combisets 5 Combisets 4 zone Combiset 19-5/16" 10-7/16" 22" 19-5/16" 19-5/16" 33-1/2" 19-5/16" 45-1/32" 19-5/16" 56-9/16" 19-5/16" 19-5/16" 19-5/16" 22" 45" 68" 1 Combiset 2 Combisets 3 Combisets Combination loosen tighten One 2 zone + one 4 zone Two 2 zone + one 4 zone Three 2 zone + one 4 zone One 2 zone + two 4 zone Two 2 zone + two 4 zone Extractor (e. g. DA 8-2) 19-5/16" 33-1/2" 19-5/16" 45" b Appliance c Tensioning screw d Clamp e Countertop f Seal Turn the tensioning screws c counter clockwise until a resistance is felt, then turn the clamps d to the left. Place the appliance in position, turn the clamps and tighten the tensioning screws until the clamps press into the countertop e, as shown. [. . . ]