User manual MIELE KM 3475

[. . . ] Operating and Installation Instructions Gas Cooktop KM 3464 / KM 3465 KM 3474 / KM 3475 KM 3484 / KM 3485 ® ® To prevent accidents and machine damage, read the Operating Manual before installation or use. UV M. -Nr. 06 818 490 2 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] ^ While holding down the knob, light the gas at the burner with a match. ^ When the flame appears, keep the control knob pressed in for 8 - 10 seconds to allow for the Ignition Safety Control to reach operating temperature. 16 Cleaning and care Cooktop Never use a steam cleaner to clean this cooktop. Pressurized steam could cause permanent damage to the surface and to components for which the manufacturer cannot accept responsibility. Do not use any sharp or pointed objects which could damage the seal between the frame and the countertop. Never use scouring agents, pads, abrasive cleaning agents, or strong cleaners, e. g. oven sprays, stain or rust removers, these could damage the surface of the appliance. Dry your cooktop thoroughly after cleaning it to prevent lime deposits. Let the appliance cool to a safe temperature before removing the grates. ^ Clean the grates, cooktop and knobs with a sponge and a mild solution of warm water and liquid dish soap. The stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored knobs These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on the knobs. 17 Cleaning and care Burners The burners can be dismantled and cleaned when cool. ^ Remove the burner parts and wash them in a solution of hot water and liquid dish soap. ^ Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. Reassembling the wok burner a b c d e Reassembling the normal and fast burners ^ Place the burner head, d, onto the burner base, e. ^ Put the grates in place. a b Be careful not to mix up the parts. Make sure that all the locating tabs and notches align exactly. ^ Place the burner cap, a, onto the burner base, b, so that the notches fit into the holes (see arrows). 18 Frequently asked questions , Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. The manufacturer cannot be held responsible for unauthorized work. The burners do not ignite after several attempts. ­ The burners are wet and soiled and/or the flame holes in the burners are soiled and clogged. ­ The cooktop is not plugged in and the circuit breaker has tripped. Fix ­ Reassemble the burners as shown in "Cleaning and Care - Burners". [. . . ] Verify proper operation after servicing. 31 Gas connection Installation and service must be performed by a qualified installer, service agency or gas supplier. This appliance must be installed with its own shut off valve and the included gas pressure regulator. Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing of that system performed in excess of ½ psi (3. 5 kPa). [. . . ]