User manual MIELE KM 3054

[. . . ] Operating and installation instructions Gas hobs KM 3054 (Town Gas or LP Gas) To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. 09 457 980 G This appliance can be used in countries other than those specified on the appliance. It is, however, set up for connection to the gas and electricity supplies in the countries specified. For use in other countries please contact the Miele spare parts or customer service department in your country. [. . . ] Wok ring The Wok ring supplied with your appliance can be used in instances where extra stability is required. Make sure that the wok ring is securely in position to prevent it from slipping. They have a small base diameter and large top diameter, generally between 35 40 cm. Com manuals search engine Energy saving tips – Use a pan lid whenever possible to minimise heat loss. € Turn the flame down promptly to a lower setting when the pan has come to the boil. Com manuals search engine Safety features Thermo-electric ignition This appliance is has a thermo-electric ignition safety device. If the flame goes out, for example if food has boiled over or if there is a sudden draught, and automatic re-ignition has been unsuccessful, the supply of gas to the burner will be cut off preventing any further escape of gas. ^ To use the burner again, turn the control clockwise to the "ß" position, and then switch it back on as normal. Safety switch-off If a burner has been used for an unusually long period (approx. ^ To use the burner again, turn the control clockwise to the "ß" position, and then switch it back on as normal. When activated, the hob cannot be switched on and the timer cannot be used. If the system lock is activated, the control lamps light up and LC appears in the minute minder display when a sensor field is touched or a control is turned. Activating ^ Simultaneously touch the - and + sensors, until LC appears in the minute minder display and a signal tone sounds. Com manuals search engine Cleaning and care , Do not use a steam cleaning appliance to clean this appliance. The steam could reach electrical components and cause a short circuit. Allow the appliance to cool down to a safe temperature before cleaning. € To avoid water marks and limescale deposits, use a soft cloth to dry surfaces that have been cleaned with water. € Food which boils over onto the hot hob can cause the burner components to discolour. € The surfaces of the burner components will become more matt with time. To avoid damaging the surface of your appliance, do not use: – cleaning agents containing soda, alkalines, ammonia, acids or chlorides, – cleaning agents containing descaling agents, – stain or rust removers, – abrasive cleaning agents, e. Pot scourers, or sponges which have been previously used with abrasive cleaning agents, – sharp pointed objects (these can damage the seal between the frame and the worktop) 30 Downloaded from www. Com manuals search engine Cleaning and care Cleaning Ceramic surface Wipe all coarse soiling off using a damp cloth. [. . . ] C Gas connection R 1/2 - ISO 7-1 (DIN EN 10226) d 90° angle Using a 90° angle will increase the building-in depth in the area of the gas connection by approx. Com manuals search engine Burner ratings Nominal rating KM 3054 Burner Gas type High setting kW Small burner Medium burner Large burner Wok Total Town gas Liquid gas Town gas Liquid gas Town gas Liquid gas Town gas Liquid gas Town gas Liquid gas 1. Com manuals search engine Conversion to another type of gas , Connection to the gas supply, or conversion from one type of gas to another, should only be undertaken by an approved and registered gas installer in strict accordance with local and national safety and building regulations. When converting to a different type of gas, the main burner jets and the small burner jets have to be changed. [. . . ]