User manual MIELE KF1801SF 30 REFRIGERATOR-FREEZER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating and Installation Instructions Fridge-Freezer Combination KF 1801 SF KF 1811 SF KF 1901 SF KF 1911 SF To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 73 3 IMPORTANT SAFETY INSTRUCTIONS When using the appliance, follow basic safety precautions, including the following: Read all instructions before installation and use to prevent accidents and machine damage. Electrical Safety ~ Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. Consult a qualified electrician if in doubt. This appliance is intended for residential use only. Improper use of the appliance can lead to personal injury and material damage. [. . . ] ^ Pull the used filter cartridge out of the appliance, 2. ^ Push the filter cartridge with cap, in a horizontal position, all the way into the opening in the base panel, 5. ^ Rotate the filter cartridge clockwise 180° until the cap is in a horizontal position, 6. The filter change needs to be confirmed before the "filter" indicator will go out. ^ Take a new filter cartridge out of the packaging and remove the protective cap. This will ensure the indicator light for the next filter change will come on at the right time. 35 Water filter Re-setting the filter indicator The filter indicator still flashes in the display. By touching the X button you can select the following settings: ^ 0: filter is installed ^ 1: filter is not installed (external filter) ^ 2: filter change confirmed ^ -: return to menu ^ Tap the X button until ^ 2 appears in the display. ^ 1 should only be selected if an external filter or bypass cartridge is being used. ^ Press and hold the access button "p" for 2 seconds to confirm the filter change. The filter is now reset. ^ Touch the access button "p" so it turns yellow. The various appliance zones are now visible. ^ Place one finger on the position of the X button and hold (the X button will not be visible). ^ While holding down the X button, press the access button "p" once. Keep holding the X button down until the following appears in the display (approx. ^ Touch the access button "p" again. 36 Water filter ^ Tap the X button until ^ - appears in the display. The "filter" indicator is no longer visible on the control panel. When you are in the Custom settings mode the door alarm is turned off automatically. Once the door is closed it is reactivated. Deactivating the water filter The ice cube maker in this appliance can be operated without the installed water filter, for example if the household water supply already uses a water filter. If you choose this option, it is important to insert a bypass cartridge. To purchase a bypass cartridge, contact Miele. After installing a new water filter discard the first 24 hours of ice production. 37 Filter Performance Data Sheet State of California Department of Public Health Water Treatment Device Certificate Number 06 - 1775 Date Issued: March 10, 2006 Date Revised: April 3, 2008 Trademark/Model Designation 9000 077095 Miele 07134220 Manufacturer: Cuno, Incorporated The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section 116830 of the Health and Safety Code for the following health related contaminants: Microbiological Contaminants and Turbidity Cysts Turbidity Organic Contaminants None Inorganic/Radiological Contaminants None Replacement Elements 9000 077104 07134220 Rated Service Capacity: 740 gals Rated Service Flow: 0. 75 gpm Conditions of Certification: Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. 38 Filter Performance Data Sheet Performance Data Sheet For Filter Model 07134220 Using Replacement Cartridge 07134220 This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53. System tested and certified by NSF International in Model 07134220 against NSF/ANSI Standard 53 for the reduction of Cysts and Turbidity and against Standard 42 for the reduction of Chlorine Taste and Odor; Nominal Particulate Class I. To a capacity of 739. 68 gallons (2800 liters). Substance Average Influent Challenge Product Average Maximum Permissible Influent Concentration Water % Product Water Concentration mg/L Concentration Reduction Concentration 166500 Minimum 50, 000/L 1 99. 99 99. 95 10. 7 11 + 1 NTU 0. 31 97. 09 0. 5 NTU Max. % Effluent Reduction 1 0. 49 99. 99 95. 42 NSF Test 516458-05 516456-05 Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Cysts* Turbidity Particulate Class I Particle size: > 0. 5 to < 1 um Chlorine taste and odor 5700000 1. 9 At least 10, 000 particles/ml 2. 0 mg/L ± 10% 30583 0. 05 99. 52 97. 3 > 85% > 50% 69000 0. 06 98. 9 96. 84 511079-03 511081-03 * Based on the use of Cryptosporium parvum oocysts Application Guidelines/Water Supply Parameters Water pressure 30- 120 psi (207 - 827 kPa) Water temperature* 33°F - 100°F (0. 6°C - 38°C) Service flow 0. 75 gpm (2. 83 lpm) IMPORTANT: Must be installed and operated in accordance with application guidelines. Flush new cartridge for 3 minutes. CAUTION: To avoid property damage due to water leakage, you MUST read and follow these operating instructions before installation and use of this product. WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. [. . . ] U1-800-999-1360 V1-800-565-6435 The appliance is supplied with a UL-listed, 3-wire power cord and NEMA 5-15 P plug ready for connection to a 120 V, 60 Hz supply. In the case of side-by-side installations, a separate outlet must be used for each appliance. Ideally, the power outlet should be next to the appliance and easily accessible. Do not connect the appliance to the power supply by an extension cord. [. . . ]