User manual MIELE GDU 60-60 INSTALLATION

[. . . ] Pull the dishwasher out of its recess enough to allow easy access to the front panel fixing screws d at the side. Push the front panel at an angle under the control panel b and flap down into the slits of the door front outer panel c. Make sure that the top edge of the front panel slides up and sits neatly in place under the control panel. Use the stoppers provided to blank off the openings in the fixing mechanism. [. . . ] ensure that the seal on the top edge of the dishwasher fits directly against the worktop. If this is not the case, adjust the height-adjustable screw feet more, (see Step 2 in the Installation section of the Operating Instructions). This step is not carried out for dishwashers installed in a kitchen with a continuous kitchen plinth facia. ­ A maximum building-in height of the machine, with the feet fully (5 cm) extended. If these measurements are less than the maximum, the door may hit the plinth facia. On each side push the spring clips aside and push the brackets right in. Carefully open the dishwasher door until the rear bottom edge of the dishwasher door hits against the plinth facia. Place a pencil horizontally at the front lower edge of the dishwasher door and draw a horizontal line across the plinth facia. To shorten the plinth facia: ­ Trim with the saw along this line, or better ­ cut along one of the cutting lines provided if this is close enough. Screw the plinth facia back on to the brackets, with the cutting line at the bottom. If the door does not open smoothly the plinth facia may need further trimming. Screw the plinth facia on with the cutting lines towards the top, and pull out evenly to adjust to the kitchen plinth rebate. It must be unscrewed, so that both spring clips can be pushed to the sides and the brackets pushed in. A toekick with mounting brackets The GDU Decor set is made to fit kitchen cabinets with a toekick height (lower edge of cabinet door to floor) of 4 to 6 inches (100 - 150 mm). 5 - 2 mm) thick material (plastic laminate , melamine , veneer , etc. To remove the adapter strip from the control panel, place the panel on a table, printed side up, and gently push down on the adapter strip near the bottom of the control panel. Install the dishwasher as instructed in its Operations Manual, making sure to remove the adapter strip (spacer bars) (see illustration). Store the adapter strips, the H-shaped bracket and the two templates that came with the dishwasher in a safe place. These will be used if you decide to convert the dishwasher back to an (i) model in the future. If you are installing the front panel from the GDU Decor set as is, proceed as follows. If you will be using a custom front panel of different dimensions or color, proceed to "Custom panels" in the next column. A front panel can be made to match the kitchen cabinets, depending on the situation, as follows: Situation A - Panel color needs changing: The front panel matches the neighboring cabinets in height, but the decor insert needs to be replaced by one of a different color. [. . . ] Adjust the door springs to the correct balance by using a Torx screwdriver: ­ turn clockwise to tighten ­ turn counterclockwise to loosen. To ensure the stability of the dishwasher, it must be attached to the countertop after it has been positioned. Open the dishwasher door and using flat head screws, secure the dishwasher to the countertop by screwing through both the mounting brackets and the steam deflector. Insert one mounting bracket into each of the slots located at the left and right side of the machine top. [. . . ]