User manual MIELE G 891

[. . . ] Operating instructions for G 891 dishwasher To prevent accidents and machine damage, read the Operating Instructions before installing or using the machine. ö] M. -Nr. 58 3 Guide to the appliance Guide to the appliance View of the dishwasher 1 Upper spray arm (not visible) 2 Cutlery tray 3 Upper basket 4 Water feed for middle spray arm 5 Middle spray arm 6 Water hardness selector 7 Lower spray arm 8 Four heigh adjustable feet 9 Filter combination 10 Salt reservoir 11 Dual compartment detergent dispenser 12 Rinse aid reservoir (with dosage selector) 13 Data plate 4 Guide to the appliance Control panel 14 Check/Refill indicators 15 Program sequence display 16 "On/Off" button 17 Program selector buttons 18 Time remaining/ Delay start display 19 Time display 20 "Delay Start" buttons 21 "Top Solo" button 22 "Start/Stop" button 23 Child safety lock 24 Door release 25 Vent for drying fan 5 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS WARNING Please follow all basic safety precautions when operating this dishwasher. This appliance conforms with all uniform safety codes and regulations. To avoid injury and machine damage, read the operating instructions carefully. The manufacturer cannot be held responsible for damage or injury caused by improper use or for uses other than those for which the appliance is intended. Repairs should only be performed by a qualified and competent person. [. . . ] The drying result may not match that of a program with a full drying cycle. The higher the temperature of the incoming water, the better the washing and drying results will be. ^ Opening the door of the dishwasher 2-3 inches (5-6 mm) at the end of the program will speed drying. 30 Operating the dishwasher Turning on the dishwasher ^ Make sure spray arms are not blocked. All indicator lights (17) next to the program buttons and the decimal point in the time display (19) light . The running time of the program selected appears in the time display (19) in hours and minutes. Note: "Delay start" or "Top Solo" must be selected before the program is started (see "Additional features"). The indicator light next to the "Start/Stop" button goes out. Do not end a program prematurely or important program steps could be omitted (e. reactivating the water softener). Starting a program ^ When selecting a program, refer to the Program Chart of the operating instructions. All indicator lights next to the program buttons, except the selected program, go out. The indicator light next to the "Start/ Stop" button comes on. Program sequence indicator lights (15) After a program has been started the current step of the program is indicated by the program sequence indicator lights (15). 31 Operating the dishwasher Time display (19) The running time of a program is shown in hours and minutes in the time display before a program is started. During a program the time left until the end of the program is displayed. The "Time left" indicator light next to the time display lights. This is due to the water inlet temperature at each intake and the load size being washed. When the dishwasher is first turned on the display shows an average time for a cold water intake. Times shown in the program chart refer to normal loads and average temperatures. Each time a program is run the electronic unit takes into account the new conditions and calculates the time required. This figure is shown in the time display. At the end of a program A program has finished when the "End" indicator light is on in the program sequence display (15) and a "0" shows in the time display (19). The indicators illuminate for the selected program just finished and any additional functions which were chosen. The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). If the dishwasher is left closed, the fan will continue for a few minutes to remove any remaining moisture. Only open the door immediately after a program has ended if dishes or cutlery are urgently needed. ^ Always turn the dishwasher off if another program is not started immediately. 32 Operating the dishwasher Turning off the dishwasher At the end of a program: ^ Press the "On/Off" button (16). [. . . ] ^ Use a jug or bowl to scoop water out of the wash cabinet. ^ Tilt the locking clamp to the side. 52 Solving problems ^ Pull out the non-return valve. ^ Rinse the non-return valve under running water. The drain pump is situated under the non-return valve (see arrow). ^ Before returning the non-return valve, check to make sure that the drain pump is not obstructed. Spin the propeller several times in both directions; it should turn smoothly. [. . . ]