User manual MIELE G 890 DISHWASHER OPERATING MANUAL

[. . . ] Operating instructions for the G 890 dishwasher To prevent accidents and reduce the risk of damaging the machine, read the Operating Manual before installing or using the machine. ö M. -Nr. 16 Setting the water softener for a hardness level of 36 - 70 gr/gal . 32 32 32 32 33 33 33 34 34 35 35 35 36 37 38 39 39 41 42 43 44 44 44 44 45 47 48 49 64 66 70 4 Guide to the appliance Guide to the appliance Miele dishwashers are available in two versions: 1. Integrated ("i") dishwashers "i"- dishwashers are designed for installation under a continuous countertop. [. . . ] The duration of the selected program will be displayed and the "Time left"lamp (19) will light. The delay time used previously will be displayed and the "Delay start" indicator lamp will light. Press the "+" or "-" button (20) to increase or decrease the delay time. If the delay time is 10 hours or longer, the display will countdown in 1 hour increments. If less than 10 hours is set, it will count down in minutes. 35 Additional features Example of how delay times are shown: up to 59 minutes: 59 between 1 hour and 9 hours - 30 minutes (example ­ 5 1/2 hours): 5. 3 0 above 10 hours: 15h To start a program before the Delay Start period has ended: Press and hold the "START/Stop" button (22) for at least one second. The indicator lamps next to the Program Selection Buttons and the decimal point in the time display will light. The indicator lamp next to the "START/ Stop" button will go out and the program will begin. The program will start automatically when the countdown reaches "0" and the "Delay start" lamp goes out. The "Time left" lamp will light and the display will show the time left in the current program. To prevent the detergent from dissolving prematurely when using the "Delay Start" feature, make certain that the dispenser is dry before adding detergent. 36 Additional features Top Solo (21) (for smaller amounts of dishware) When this feature is selected, the majority of the water is directed to the top and middle spray arms of the dishwasher. Its use is recommended when all the dishes or cutlery needing cleaning can be loaded into the upper basket and cutlery tray. Note: Lightly soiled plates or serving platters can still be placed in the bottom basket if large spaces are left between them. Do not place dishes, bowls or other hollow containers in the bottom basket. Adjusting the upper basket to its lowest position will allow it to accommodate larger plates. Because smaller amounts of dishware are being washed, the amount of detergent used can be reduced accordingly. For example, using Top Solo with the INTENSIVE 55°C/130°F program uses 3. 2 gallons (12 liters) of water instead of the usual 5 gallons (19 liters). The length of the program will appear in the time display (19) in hours and minutes and the "Time left" lamp will be lit. For all programs except "Energy Saver" and "Rinse & Hold", the "Top Solo" indicator lamp will illuminate and the program duration will change. The indicator lamp next to the "START/ Stop" button will go out and the program will begin. At the completion of the program "Top Solo" will be canceled. 37 Unloading the dishwasher Unloading the dishwasher Dishes tend to break and chip easier when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If the door is opened at the completion of the drying cycle, the dishes will cool much faster. [. . . ] If the hose is too long, coil it neatly and place it behind the machine. Cut the 3/8" copper tubing after the valve. Install the 3/8" compression to 3/4" MHT (Male Hose Thread) adapter (supplied with the machine), as illustrated. Electrical wiring and components should not come into contact with any plumbing fixtures or hoses. 67 Plumbing Drain system specifications: The machine comes equipped with: ­ A 5 ft. long (1. 5 m) flexible drain hose with an internal diameter of 7/8" (22 mm). [. . . ]