User manual MIELE G679 SCI

[. . . ] Operating instructions for dishwashers It is essential to read these operating instructions before installing or using the machine, to avoid the risk of accident or damage to the machine. Q M. -Nr. 24/25 Flap up racks, positioning rail, insert for glasses, adjusting upper basket . 81 3 Guide to the appliance Guide to the appliance View of the machine Control panel (12) 4 Guide to the appliance 1 Upper spray arm (not visible) 2 Cutlery tray 3 Upper basket 4 Water duct for middle spray arm 5 Middle spray arm 6 Water hardness selector 7 Lower spray arm 8 Four height adjustable screw feet 9 Filter combination 10 Salt reservoir 11 Dual compartment detergent dispenser 12 Control panel 13 Rinse aid reservoir (with dosage selector) 14 Adhesive label with programme names 15 Data plate 16 Indicator lights 17 Touch pads 18 Function touch pad Top Solo 19 O - Off touch pad 20 I - On touch pad o Label with programme names An adhesive label is supplied with the dishwasher. This can be placed in the indented area next to the programme touch pads. [. . . ] See the "Additional functions" chapter for further information. 35 Programme chart Programme chart Programme When to use Detergent A1) Compart- Compartment ment I II (Pre-wash) (Wash cycle) B2) Compartment II (Wash cycle) Normal and Universal Programmes NORMAL 55 ° (Touch pad f) This programme is for normal everyday loads and is particularly suitable for chlorine free detergent This programme is for normal everyday loads as UNIVERSAL 55 °, but higher temperatures for stubborn dried on particles 100% 100 % UNIVERSAL 55 ° 3) (Touch pad c) UNIVERSAL 65 ° (Touch pad b) 20 % 20 % 80% 80 % 100 % 100 % Special programmes ECONOMY 55 ° (Touch pad d) for full loads with very light soiling, e. g. coffee cups, or: for half a, normal everyday load "Gentle programme", for lightly soiled crockery and for heat sensitive crockery 50 % 50 % GENTLE 45 ° (Touch pad e) 50 % 50 % The amount dispensed will depend on the type of detergent being used: A 1) Use this method for: ­ detergents which contain phosphates and chlorine (except liquid detergent) Divide the total amount proportionally between compartment I and compartment II. B 2) Use this method for: ­ detergent which is chlorine and phosphate free ­ detergent which is chlorine free but contains phosphates ­ liquid detergent In this instance the whole amount is placed in compartment II. For the NORMAL programme and the UNIVERSAL programmes use at least 30 ml (or g) detergent unless advised to use more by the manufacturer, then use what they advise. When setting "Top Solo" add detergent to compartment II only (approx. 2/3 of total amount for full load) or according to degree of soiling. 36 Programme cycle Prewash Consumption Energy Water cold (15 °C) kWh Water hot (55 °C) Water Litres 4) Time Minutes (approx. ) Water Water cold hot (15 °C) (55 °C) Main wash Interimrinse Final rinse Dryingphase X 55 ° X X 55 ° X 65 ° X X 65 ° X 65 ° X 65 ° X 1. 3 0. 9 13 91 78 X X 1. 3 0. 9 17 85 72 X X X 1, 4 1. 0 17 88 74 X X 55 ° X 45 ° X X X 55 ° X 55 ° X X 1. 25) 1. 2 0. 75) 0. 6 13 17 605) 68 505) 55 3) Standard programme (see chapter "Comparison tests") 4) Average consumption with water hardness 310 mg/l ( 17 °d German scale ), (see section "Water softener) 5) with half loads (6 place settings) 37 Switching on and off Switching on and off Switching on Open the door. The "On" indicator light comes on. For information The "Reactivation" process is carried out before a wash programme. The hardness level of the inlet water dictates how often (after how many programmes) water needs to be softened. For example with a water hardness degree of 380 mg/l (21 °d German scale) reactivation takes place after every 3 programmes. With a water hardness degree of 140 mg/l (8 °d German scale) reactivation takes place after 8 programmes. Do not cancel the programme prematurely, as important programme steps such as preparing the water softener may be left out. Starting a programme Press the touch pad for the required programme. The indicator light comes on in the touch pad pressed. If required select "Top solo" (2) before starting the programme. The programme starts. Programme end A buzzer sounds at the end of the programme cycle. You can switch this buzzer off (see section on "Additional functions"). 38 Switching on and off Programme interruption A programme is interrupted as soon as the door is opened. If the door is closed again the programme will continue from the position it was interrupted. Only open the door if absolutely necessary and exercise caution when doing so. Close the door firmly making sure that it clicks into place. Switching off On completion of a programme: Open the door slightly. If the indicator light in the programme touch pad still glows, the relevant programme has not yet finished. Open the door completely and unload the dishwasher. (see section "Remove load") Close the door. whilst holiday: Turn off the stopcock. Programme change A change can be made to the programme selected before the door is closed. If a programme has already begun first switch off the dishwasher, and then start again. 39 Remove load Remove load Hot crockery will chip and break more easily. After switching off let it cool down in the dishwasher until it is comfortable enough to handle, before you unload it. [. . . ] WARNING THIS APPLIANCE MUST BE EARTHED 75 Electrical connection Non rewireable plugs BS 1363 If this machine or appliance is fitted with a non-rewireable plug, the following information applies: If the socket outlets are not suitable for the plug supplied with this product, it must be cut off and an appropriate plug fitted. The plug cut from the flexible cord should be disposed of and on no account be inserted into a socket elsewhere in the house (electric shock hazard). The fuse cover must be refitted when changing the fuse, and if the fuse cover is lost, the plug must not be used until a suitable replacement is obtained. The colour of the correct replacement cover is that of the coloured insert in the base of the plug, or the colour that is embossed in words in the base of the plug (as applicable to the design of plug fitted). [. . . ]