User manual MIELE G 663 SCVI INSTALLATION MANUAL

[. . . ] Installation instructions Integrated dishwasher To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 33 2 IMPORTANT SAFETY INSTRUCTIONS Installation Installation, maintenance and repair work should be by a Miele authorized service technician. Work by unqualified persons could be a hazard and may void the warranty. This equipment is not designed for maritime use or for use in mobile installations such as caravans or aircraft. [. . . ] ^ Measure the distance X between the round hole in the machine outer door panel (shown in inset) and the lower edge of the adjoining cabinet door. ^ Using a pencil, lightly draw a vertical centerline on the panel (See illustration on the next page). ^ Draw a horizontal line X inches up from the bottom edge of the panel. For two piece panels: Two piece panels should be made so that any joining hardware is flush with the back of the panel . In certain instances, you may be able to use the mounting bracket supplied with the machine to secure both pieces to the dishwasher. Consult your cabinet supplier / maker for the best method of joining the panels. ^ Place the door panel on a flat surface, good side face down, being careful not to scratch the surface. When mounting the two pieces, make sure that the desired finished panel height is maintained. 19 Installation ^ Place the bracket on the door panel so the notches, a, cross the previously drawn centerline, and the bottom of the bracket lines up with the horizontal X line. ^ Mark and drill pilot holes for the screws using a 3/32" (2. 5 mm) drill bit. ^ Attach the bracket to the back of the panel, using the 14 screws provided. The top four pair of holes, only need to be secured once per pair. ^ Double check the location of the bracket before mounting the panel to the dishwasher. The door handle must be installed on the panel before it is attached to the machine. It should be located in the center of the panel at a height that will match the surrounding drawer handles. Any screws used to attach the door handle must be countersunk so that the rear of the front panel remains flat. 20 Installation Attach the front panel to the dishwasher ^ Open the door 2 - 4" (5 - 10 cm). The "T" shaped hanger behind the door handle should fit easily into its respective hole. ^ Place the lower mounting clips into the slots of the dishwasher door as shown in the illustration. ^ Seat the U shaped slots of the upper bracket onto their respective locator pins. ^ Press the panel against the door and slide down so that all the brackets catch. 21 Installation 7. Adjust and secure the front panel Once installed, the panel can be raised or lowered up to 1/16" (2 mm) to match the cabinet lines. ^ Once this side of the panel lines up with the cabinets, secure it by tightening the upper screw on the edge of the dishwasher door. ^ Insert the supplied end caps into the four screw holes. Adjust one side of the door panel at a time using a T20 Torx screwdriver. Do not use a power screwdriver to adjust or secure the decorative panel to the dishwasher. ^ If the upper screws on the edge of the door are not loose, loosen them slightly. ^ The panel can be raised or lowered by turning the lower screw on each side of the dishwasher door. [. . . ] Pass the permanent power supply cable through the strain relief and secure it to the terminal box. Connect: L1 N (Black) to L on terminal block (White) to N on terminal block GRND To ground connector GROUNDING INSTRUCTIONS This appliance must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the appliance. Use copper conductors only. , Hardwiring the dishwasher should only be done if required by local electrical codes, and then in accordance with those codes. Do not cut the plug off the power supply cord and connect it directly to the house wiring. 31 Installation 12. Test the unit Once the dishwasher is level and secured it should be tested. [. . . ]