User manual MIELE G 590 DISHWASHER OPERATING MANUAL

[. . . ] Extension cords do not guarantee the required safety of the appliance (e. g. To guarantee the electrical safety of this appliance continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. ~ Before installation or service, ~ Do not use an extension cord to ~ Be certain your appliance is 4 IMPORTANT SAFETY INSTRUCTIONS Installation and connected in compliance with the installation instructions. ~ The dishwasher must be installed ~ , WARNING - Fire hazard ~ Installation and repair work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. [. . . ] Compartment I holds a maximum of 2 teaspoons (10 ml). 27 Use Turning on ^ Open the water supply, if it is closed. The "g" indicator and the indicator of the last set program lights up. Selecting and starting a program Choose your program according to the type of load and soiling. The time display shows the duration of the selected program in hours and minutes. . If the "Turbo" or "Tab" option is selected, the respective indicator lights up ^ Select an additional function if desired, see "Additional functions" for more information. the water softening) may be interrupted. 28 Program guide Program When to use Pre-rinse 1 2 Program sequence Main wash Interim rinse 1 x x 2 x x Final rinse Drying Pots & Pans For normally soiled pots and pans with dried on food, also for heavily soiled dishware, use 120% of normal detergent dose For normally soiled dishware For temperature sensitive glassware and lightly soiled dishware, use 50% of normal detergent amount, includes sensor controlled Glasscare Extended wash time, for sanitizing normally soiled dishware with dried on food "Quick program" for lightly soiled dishware, e. g. party dishware or to remove salt traces from the wash cabinet after refilling salt, includes sensor controlled Glasscare, not suitable for detergent tabs To rinse dishes when a complete program is not needed detergent is not recommended x Normal China & Crystal x as required x x as required x x x x SaniWash x x x x Express x x x x Rinse & Hold x Usage: Electric: 0. 01 - 1. 23 kWh Water: 1. 3 - 6. 3 gal (5 - 24 l) If the option "Turbo" is selected the program run-time may shorten up to 50 minutes and the energy usage will increase. When "Tab" is selected the energy consumption may increase and the program run-time may increase by up to 15 minutes. 29 Use Time display Before the program starts, the time display shows the running time of the selected program in hours and minutes. During the running program the remaining time is shown in the time display. The running time for the same program may vary depending on the intake water temperature, load size and soiling. When a program is selected for the first time, a time is shown which equals an average program running time with cold water. Each time a program is run, the electronic adjusts the program running time according to the intake water temperature and the load size. At the end of a program At the end of a program the optical function light flashes slowly with the door closed. Gel detergent should not be used when selecting "Delay Start", the detergent could leak out of the compartment. If you press and hold the "d" button the time with automatically count up to 24^. ^ Close the door. 33 The time will count down to the program start: in 1-hour-steps over 10 hours, in 1-minute-steps under 10 hours. The display shows the remaining time, the indicator "d" goes out and the indicator of the selected program lights. 15 h = 15^ Starting a program before the delay start has elapsed A program can be started before the delay start time has elapsed. The program begins. Additional options Buzzer A signal sounds at the end of a program and when a fault occurs. The buzzer at the end of a program sounds five times in quick succession for up to one hour. ^ Press the "Program" button and at the same time turn the dishwasher on with "g". ^ Hold the program button until the lower right program indicator comes on. ­ "p 1": Buzzer is turned on ­ "p 0": Buzzer is turned off ^ Press the "Program" button to change the setting. ^ Turn the dishwasher off with "o". Default settings All settings can be reset to the factory default. [. . . ] Danger of suffocation! Disposal of an old machine Old appliances may contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Ensure that the appliance presents no danger to children while being stored for disposal. Before discarding an old appliance, unplug it from the outlet, cut off its power cord and remove any doors to prevent hazards. 56 Electrical connection , Installation, repairs and other work by unqualified persons could be dangerous. Check that the voltage, frequency and fuse rating shown on the data plate match the household mains supply. [. . . ]