User manual MIELE G 572 DISHWASHER OPERATING MANUAL

[. . . ] Extension cords do not guarantee the required safety of the appliance (e. g. To guarantee the electrical safety of this appliance continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. ~ Before installation or service, ~ Do not use an extension cord to ~ Be certain your appliance is 4 IMPORTANT SAFETY INSTRUCTIONS Installation and connected in compliance with the installation instructions. ~ The dishwasher must be installed ~ , WARNING - Fire hazard ~ Installation and repair work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. [. . . ] The indicators for "Start/Stop", "Rinse" and the program selected will light up. If the options "Turbo" and/or "Tab" are selected the relevant indicators will also light up. Otherwise important program steps may be interrupted. 27 Program guide Program When to use Pre-rinse 1 2 Program sequence Main wash 1 X X Interim rinse 2 X X Final rinse Drying Pots & Pans For normally soiled pots and pans with dried on food, also for heavily soiled dishware, use 120% of normal detergent dose For normally soiled dishware X Normal China & Crystal X X X X as required X X X X as For temperature sensitive glassware and required lightly soiled dishware, use 50% of normal detergent amount Extended wash time, for sanitizing normally soiled dishware with dried on food "Quick program" for lightly soiled dishware, e. g. party dishware Not suitable for detergent tabs To rinse dishes when a complete program is not needed detergent is not recommended X SaniWash X X X X Express X X X X Rinse & Hold Usage: Electric Water 0. 01 - 1. 23 kWh 1. 3 - 5. 3 gal (5 - 20 l) 28 Use Time display Before the program starts, the time display shows the running time of the selected program in hours and minutes. During the running program the remaining time is shown in the time display. The running time for the same program may vary depending on the intake water temperature, load size and soiling. When a program is selected for the first time, a time is shown which equals an average program running time with cold water. Each time a program is run, the electronic adjusts the program running time according to the intake water temperature and the load size. If no key is pressed the time display turns off automatically after a few minutes. Press any key (except K) to show the time display again. At the end of a program The program is complete when a "0" appears in the time display and the "End" indicator lights up. Unloading the lower basket first will prevent water drops from the upper basket and cutlery tray (depending on model) from dropping onto dishes in the lower basket. To start again at 30 minutes, press the "Delay Start" button twice. The time will count down to the program start: in 1-hour-steps over 10 hours, in 1-minute-steps under 10 hours. The display shows the remaining time, the "Delay Start" indicator goes out and the "Start/Stop" indicator lights. 15 h = 15^ Starting a program before the delay start has elapsed A program can be started before the delay start time has elapsed. ^ Press and hold the "Start/Stop" button for at least one second. The "Delay Start" indicator goes out and the "Start/Stop" indicator flashes. The program starts and the "Start/Stop" indicator lights up. 32 Additional options Default settings All settings can be reset to the factory default. ^ Press and hold the "Start/Stop" button and at the same time turn the dishwasher on "K". Hold the "Start/Stop" button until the "Start/Stop" indicator lights up. The "Delay Start" indicator gives on long flash and two short flashes in intervals. ^ To reset the dishwasher to the factory default settings, press the "Start/Stop" button. [. . . ] Please contact your local recycling authority about the possibility of recycling these materials. Ensure that the appliance presents no danger to children while being stored for disposal. Before discarding an old appliance, unplug it from the outlet, cut off its power cord and remove any doors to prevent hazards. 54 Electrical connection , Installation, repairs and other work by unqualified persons could be dangerous. Check that the voltage, frequency and fuse rating shown on the data plate match the household mains supply. A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. [. . . ]