User manual MIELE G 2141SC PREFINISHED, FULLSIZE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 2141 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 55 3 IMPORTANT SAFETY INSTRUCTIONS WARNING When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Keep these operating instructions in a safe place and pass them on to any future user. the voltage and frequency listed on the data plate correspond with the household electrical supply. disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. [. . . ] The dishwasher continues to use electricity until turned off with the s button. Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed, the program will continue from where it was interrupted. , Open the door with care. Close the door firmly until it clicks into place. Changing a program If the detergent flap is already open do not change the program. If a program has already started and you wish to change it: ^ Press the "Start/Stop" button for at least one second. ^ Select and start the desired program. Preparing your appliance for an extended vacaion If you elect to turn off the water to your home for an extended period of time, please note that this may not be enough to reduce the risk of a leak. To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc. 28 Additional options Default settings All settings can be reset to the factory default. ^ Press the "Start/Stop" button and at the same time turn the dishwasher on "s". Hold the "Start/Stop" button until the "Start/Stop" indicator comes on. The bottom program indicator flashes once long and twice short in intervals. ­ The "Rinse" indicator flashes: All settings are the factory default. ­ The "Rinse" indicator is off: At least one setting was changed. ^ To reset the dishwasher to the default settings, press the "Start/Stop" button. ^ Turn the dishwasher off "s". 29 Frequently asked questions With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Issue The Start / Stop indicator does not flash after the dishwasher is turned on with "s". The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. See data plate for minimum amperage. The fuse has tripped. The drain pump is running when the door is open. There may be a technical ­ Turn the dishwasher off fault. ­ Contact Miele Technical Service. 30 Frequently asked questions Problems water Intake / Drain Issue The "Intake / Drain" indicator flashes. ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. See "User Maintenance Instructions" for more information on the above. ­ Remove any kinks in the drain hose. 31 Frequently asked questions General problems with the dishwasher Issue The display turns off. [. . . ] A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electrical current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. [. . . ]