User manual MIELE G 1262SCVI FULLY-INTEG RATED, SLIMLINE DISHWASHER OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Dishwasher G 1262 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 57 3 IMPORTANT SAFETY INSTRUCTIONS WARNING When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Keep these operating instructions in a safe place and pass them on to any future user. the voltage and frequency listed on the data plate correspond with the household electrical supply. disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. [. . . ] This means under the sink for a dishwasher, at the laundry bib for your washer, etc. Changing a program If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Open the door. The program starts. Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed, the program will continue from where it was interrupted. , Open the door with care. Close the door firmly until it clicks into place. 30 Additional options Options With the "Options" button the functions "Turbo" and "Tab" can be selected. ^ Press and hold the "Options" button until the indicator of the desired function lights up. The option will remain active for all programs until the setting is changed again. ^ A program can now be started as usual or the dishwasher can be turned off "V". Tab To achieve the best results, the dishwasher can be programmed for the type of detergent being used. The "Options" button can be used to select between normal detergents (powder or gel ) and tabs. Depending on the program selected the run-time may be extended considerably. If the "Tab" indicator is not lit, the dishwasher is set for normal detergent. If the "Tab" indicator is lit than the program sequence is adapted to suit detergents than contain rinse aid (as well as other components where applicable). The cleaning and drying performance of normal detergents versus tabs varies greatly. Turbo The "Turbo" function can be used to reduce the program run-times, in programs in which the option is available. Using the "Turbo" option during the "Express" program will rinse the dishes without heat, e. g. to avoid smells, if a complete program is not yet needed. 31 Additional options Delay start The starting time of a program can be delayed. With a delay start time between 30 minutes and 9 hours 30 minutes the delay is set in 30 minute increments. When using the "Delay Start" function, make sure that the detergent compartment is dry before adding detergent. Otherwise the detergent could stick together and not completely rinse out. Gel detergent should not be used when selecting "Delay Start", the detergent could leak out of the compartment. If you press and hold the "d" button the time with automatically count up to 24^. ^ Close the door. 32 The time will count down to the program start: in 1-hour-steps over 10 hours, in 1-minute-steps under 10 hours. The display shows the remaining time, the indicator "d" goes out and the indicator of the selected program lights. [. . . ] A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electrical current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. [. . . ]