User manual MIELE G 1530

[. . . ] Operating instructions for dishwashers To avoid the risk of accidents or damage to the appliance it is essential to read these instructions as well as the installation plan before it is installed and used for the first time. G M. -Nr. 65 4 Description of the appliance Appliance overview a Upper spray arm (not visible) b Cutlery tray (depending on model) c Upper basket d Middle spray arm e Air inlet for drying (depending on model) f Lower spray arm g Filter combination h Data plate i Child safety lock in door grip (not visible) j Rinse aid reservoir k Dual compartment detergent dispenser l Salt reservoir 5 Description of the appliance Control panel a Programmes b Glass care indicator c Display d Tab indicator e Programme sequence indicators f On/Off button s g Check/Refill indicators h Start/Stop button with indicator light i Delay start button with indicator light j Tab button k Programme selector button This instruction book applies to several different dishwasher models. The specific dishwasher models below are referred to as follows: G 1520 / G 1530 = G 1XXX G 2520 / G 2530 = G 2XXX The model numbers G 1XXX and G 2XXX used in this book refer to the model designation specified on the data plate of the appliance (and not the description on the control panel). The data plate is located at the top right hand side of the door. 6 Warning and Safety instructions Delivery This appliance conforms to current safety requirements. [. . . ] The different programmes and their uses are described in the programme chart later on in this booklet. 34 Operation Display The duration of the programme selected appears in hours and minutes in the display before the programme begins. During the programme, the time left until the end of the programme is displayed. This is partly because of the water inlet temperature at each intake, and partly because of the amount and soiling level of the crockery. When a programme is selected for the first time, the display shows an average time for a cold water intake. The times shown in the programme chart refer to standard test loads and temperatures. Each time a programme is run, the electronic unit takes the new conditions into account, and calculates the time required. Programme sequence indicators After a programme has been started the current stage of the programme is indicated by the programme sequence indicator lights. At the end of a programme 0 appears in the display when the programme has finished. The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). , To prevent the risk of steam damage to the worktop edging above the dishwasher, it is advisable to leave the door closed until you are ready to unload the crockery. Alternatively you can open the door fully until the crockery is cool enough to unload. Do not leave the door only partially open. Glass care indicator The green "Glass care" indicator light will come on when you select a programme that is suitable for glassware. 35 Operation Switching off At the end of a programme: ^ Switch the dishwasher off with the On/Off button s. The dishwasher will continue to use electricity until the On/Off button s is switched off. whilst on holiday, the stopcock should be turned off. Interrupting a programme A programme is interrupted as soon as the door is opened. If the door is closed again, the programme will continue from the point it was at before the door was opened. , Water in the dishwasher may be hot. Only open the door if absolutely necessary and exercise extreme caution when doing so. Then close the door firmly making sure that it clicks into place. Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If you open the door fully after switching off, the dishes will cool much faster. ^ First unload the lower basket, then the upper basket and cutlery tray (depending on model). This will prevent water drops from the upper basket and cutlery tray from falling onto the dishes in the lower basket. Changing a programme Important: If the detergent dispenser flap has already opened, do not change the programme. If a programme has already started and you wish to change it, proceed as follows: ^ Press the Start/Stop button for at least one second. ^ Select the programme you want and then start it. 36 Operation Additional functions Tab function You can programme your dishwasher to ensure excellent results when using tablet detergents by simply selecting the "2 in 1" or "3 in 1" function using the Tab button. The programme sequence will be adjusted to the type of detergent selected. "2 in 1": When the "2 in 1" function is selected, the programme sequence is adjusted for "2 in 1" tabs (detergent containing rinse aid). [. . . ] Extension leads do not guarantee the required safety of the appliance (e. g. danger of overheating). WARNING: THIS APPLIANCE MUST BE EARTHED 62 Plumbing Connection to the water supply , Water in the dishwasher must not be used as drinking water. ­ The dishwasher may be connected to a cold or hot water supply, max. We would only recommend connection to a hot water supply if it is economical, e. g. When connected to a hot water supply all programme stages which would otherwise be carried out with cold water will be carried out with hot water. [. . . ]