User manual MIELE G 603 PLUS

[. . . ] Operating instructions for dishwashers It is essential to read the operating and installation instructions before installing, commissioning or using the machine, to avoid the risk of accidents or damage to the machine. G M. -Nr. see Installation Instructions 3 Guide to the appliance Appliance overview 1 2 3 4 5 6 7 Upper spray arm (not visible) Cutlery tray Upper basket Water feed for middle spray arm Middle spray arm Lower spray arm Rinse aid reservoir (with dosage selector) 8 9 10 11 12 13 14 Dual compartment detergent dispenser Data Plate Control panel In-operation control light Salt reservoir Filter combination Four height adjustable screw feet 4 Guide to the appliance Control panel (10) 15 16 17 18 19 "On" button "Off" button Check/Refill indicators Programme names Programme buttons / indicator lights Please note: The programme list is covered by a protective foil on delivery. ^ Carefully remove the protective foil before using the appliance for the first time. 5 Warning and Safety instructions Installation This appliance conforms to current safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. [. . . ] The deeper section (for large items of cutlery) must be on the left hand side. The flap up rack cannot be lifted up if the deeper section is on the right hand side. Spoon heads should be placed in contact with at least one of the serrated retainers on the base of the cutlery tray to ensure that water runs off them freely. If spoon handles do not fit between the holders then lay them the other way round making sure that the head of the spoon is in contact with the support on the bottom of the tray. 26 Loading the dishwasher Items not suitable for dishwashers: ­ Wooden cutlery and crockery or items with wooden parts: these may discolour and fade. The glue used in these items is not dishwasher-proof and wooden handles may come loose after being washed in a dishwasher. ­ Craft items, antiques, valuable vases and decorative glassware are also not suitable for dishwashers. The high temperatures in the dishwasher may cause them to melt or lose shape. ­ Copper, brass, tin and aluminium items may discolour or become matt. We recommend: ­ When purchasing new crockery and cutlery, make sure they are dishwasher-proof. ­ If delicate glassware is washed in the dishwasher ensure that only very low temperatures are used (see programme chart). Please note Silverware previously cleaned with a silver polish may still be damp or spotted at the end of a programme, where water has not run off smoothly. Silver treated in a silver immersion dip is usually dry at the end of a programme but may discolour. Silver which has been in contact with foods containing sulphur can discolour. These include egg yolk, onions, mayonnaise, mustard, pulses, fish, fish brine and marinades. , Aluminium components (e. g. a grease filter) must not be cleaned with caustic alkaline commercial or industrial cleaning agents. These may damage material, or in extreme cases, cause severe chemical reaction. See section "Adding detergent" for information on suitable detergents. 27 Operating the dishwasher Detergent Detergent manufacturers give the required amount of detergent for a particular programme on their packaging. ^ Use at least 20 ml of detergent for a full load in the following programmes: - Intensive, - Universal plus, - Universal, - Normal, - Economy. If the manufacturer recommends a larger amount of detergent, use the amount recommended. Failure to dispense the recommended amount of detergent may impair cleaning results. , Only use detergents formulated for domestic dishwashers. Do not use washing up liquid. ^ You can use conventional powder detergent, tablets or liquid dishwasher detergent. Refer to the dosing instructions given by the manufacturer on the packaging. ^ Detergent tablets should only be put into compartment II if this is recommended by the manufacturer. If the manufacturer recommends inserting tablets in the cutlery basket do not do so. [. . . ] ^ Replace the filter and seal, making sure they are sitting correctly. ^ Reconnect the inlet hose to the stopcock, making sure it goes on correctly and is not cross-threaded. If there is a leak, the inlet hose might not be on securely, or it may have been screwed on at an angle. Unscrew and reconnect the water inlet valve correctly. 49 Solving problems Cleaning the drain pump and non-return valve If the water has not been pumped away at the end of a programme the drain pump or the non-return valve might be blocked. [. . . ]