User manual MIELE G 1XXX

[. . . ] Operating instructions for dishwashers To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions as well as the installation plan before it is installed and used for the first time. en - GB M. -Nr. 61 4 Guide to the appliance Appliance overview a Upper spray arm (not visible) b Cutlery tray (depending on model) c Upper basket d Middle spray arm e Air inlet for drying (depending on model) f Lower spray arm g Filter combination h Data plate i Child safety lock in door grip (not visible) j Rinse aid reservoir k Dual compartment detergent dispenser l Salt reservoir 5 Guide to the appliance Control panel a Programmes b Delay start display cProgramme sequence indicator d On/Off button K e Check/Refill indicators f Start/Stop button with indicator light g Delay start button h Turbo button with indicator light i Programme selector button This instruction book applies to several different dishwasher models. The specific dishwasher models below are referred to as follows: G 1143 etc. = G 2XXX The model numbers G 1XXX and G 2XXX used in this book refer to the model designation specified on the data plate of the appliance (and not the description on the control panel). [. . . ] Refer to the manufacturer's packaging as to whether the combi tabs are suitable for the water hardness level in your area. Please note that the cleaning and drying results of tab detergents can vary greatly. For optimum cleaning and drying results use Miele dishwasher detergent and add Miele salt and Miele rinse aid separately. Dispensing ^ Follow the dosage recommended by the manufacturer on the packaging. ^ Unless directed otherwise, use one detergent tab or add 20 to 30 ml detergent in compartment II, depending on the level of soiling. With very heavy soiling you can also add a small amount of detergent to compartment l (see "Programme chart"). ^ Do not use tabs with the "Quick" programme, as they will not dissolve properly. Failure to dispense the recommended amount of detergent may impair cleaning results. , Only use detergents formulated for domestic dishwashers. Do not use washing-up liquid. Miele branded dishwasher cleaning products are available from the Miele Spare Parts Department or via the Internet at www. miele-shop. com. Active ingredients Modern detergents contain various active ingredients, the most important of which are: ­ Phosphates to prevent calcification. Most dishwasher detergents contain phosphates and are mildly alkaline with enzymes and oxygen based bleaching agents. These detergents allow you to adjust the amount dispensed according to the size of load and level of soiling. These are suitable for most levels of soiling. 32 Operation , Avoid inhalation of powder The flap is always open at the end of a programme. detergents and do not ingest dishwasher detergent. Dishwasher detergents contain irritant or corrosive ingredients which can cause burning in the nose, mouth and throat if swallowed, or inhibit breathing. Consult a doctor immediately if detergent has been swallowed or inhaled. Keep detergent and other household agents out of the reach of children at all times. To avoid the danger of children coming into contact with the dishwasher detergent, only add detergent just before starting the programme and close the door, activating the child safety lock (if your dishwasher is fitted with one). ^ Add the required amount of detergent and close the flap. ^ Make sure that the detergent packaging is properly closed after use to avoid it getting damp and becoming lumpy. There are markings in compartment II to assist with dispensing: 20, 30. 20 or 30 ml when the door is open in a horizontal position. Adding detergent ^ Press the opening catch on the detergent dispenser. The flap will spring open. 33 Operation Switching on ^ Make sure the spray arms are not obstructed. The Start/Stop indicator light flashes and the indicator light comes on next to the last programme selected. Starting a programme ^ Select the programme required with the programme selector button. [. . . ] Replacement fuses and fuse covers may be purchased from your local electrical supplier. , All electrical work must be WARNING: THIS APPLIANCE MUST BE EARTHED 58 Plumbing The Miele waterproof anti-leak system Providing your dishwasher has been installed correctly, the Miele waterproof anti-leak system will protect you from water damage throughout its lifetime. ­ The water pressure (flow pressure at the take-off point) must be between 30 and 1000 kPa (0. 3 and 10 bar). If the water pressure is too high, a pressure reducer valve must be fitted. Connection to the water supply , To avoid any damage to the , Water in the dishwasher must not be used as drinking water. ­ The dishwasher may be connected to a cold or hot water supply, max. We would only recommend connection to a hot water supply if it is economical, e. g. [. . . ]