User manual MIELE EGW 4060-14

[. . . ] Operating and installation instructions EGW 4050-14 / EGW 4050-29 EGW 4060-14 / EGW 4060-29 To avoid the risk of accidents or damage to the appliance it is essential to read these operating instructions before it is installed and used for the first time. GHirZ M. -Nr. 25 3 Description of the appliance a On/Off switch (lights up) b Temperature control c Warming drawer d Non-slip mat e In-operation indicator 4 Warning and Safety instructions To avoid the risk of accidents to the appliance please read these instructions carefully before using it for the first time. They contain important information on its installation, safety, use and maintenance. The use of the appliance by the elderly or infirm or those who have not used the appliance before should be supervised by a competent and responsible person to avoid the risk of injury. [. . . ] Always use heat-resistant gloves to remove heated crockery from the drawer. The load bearing capacity of the appliance, irrespective of its height, is 25 kg maximum. When the drawer is closed, you can tell when the appliance is switched on because the On/Off switch illuminates through the hole in the front of the drawer. 10 Operation Using the drawer ^ Place crockery inside the drawer. ^ Close the drawer gently: if you use too much force, it can spring open again. The temperature dial must only be turned in a clockwise direction as far as it will go and then back again. When the temperature is reached, the heating element switches itself off. When the temperature falls below that selected, the heating element switches on again automatically. The temperature scale around the dial is shown in symbols rather than in °C. The symbols represent the most suitable temperature for the type of crockery depicted: ­ b approx. Aluminium fronts Aluminium is affected by the way that light falls on it, by the surrounding environment and by the angle you observe it from. Aluminium surfaces may suffer discolouration or damage if soiling is left on them for too long. Do not use: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents, ­ stainless steel cleaning agents, ­ cleaning agents containing descaling agents, ­ dishwasher cleaner, ­ oven sprays. Appliance front, control panel and interior Allow the appliance to cool down to a safe temperature before cleaning. ^ All surfaces and controls should be cleaned using a Miele E-Cloth or with warm water and a little washing up liquid applied with a soft sponge or cloth. To prevent the risk of scratches and damage to the surface structure, pay particular attention to the following cleaning instructions for glass or metal fronted appliances. Glass fronts The appliance front and controls are susceptible to scratches and abrasions. pot scourers or sponges which have been previously used with abrasive cleaning agents, 14 Cleaning and care Titanium finish fronts Titanium surfaces have a velvety finish which does not show fingerprints. pot scourers or sponges which have been previously used with abrasive cleaning agents, ­ sharp metal tools, ­ oven sprays. Stainless steel fronts The appliance front is susceptible to scratches and abrasions. Stainless steel surfaces can be cleaned using a Miele E-Cloth or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. Do not use: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents, e. g. powder cleaners and cream cleaners, Never dry the anti-slip mat in the oven. [. . . ] Any air gap created acts as additional insulation and helps prevent heat-loss. ^ Then position the trim as shown in the illustration so that they are flush with the side walls and the back wall of the housing unit and then stick them to the plate warmer. If the unit does not have a back wall you do not need the third trim. Ensure that the housing unit is aligned at a right angle. ^ Open the drawer, and use the 2 screws supplied to secure the appliance to the side walls of the housing unit. [. . . ]