User manual MIELE G 4570 SCVI

[. . . ] Operating Instructions Dishwasher G 4570 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 58 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Keep these operating instructions in a safe place and pass them on to any future user. the voltage and frequency listed on the data plate correspond with the household electrical supply. disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. [. . . ] The horizontal marks in compartment II indicate the levels of approximately 1 ¼ and 2 tablespoons (20 and 30 ml) respectively. The marks indicate the approximate fill level in ml when the door is open in a horizontal position. 28 Use Turning on ^ Open the water supply, if it is closed. The U indicator and the indicator of the last set program light up. Starting a program ^ Start the program by closing the door. the water softening) may be interrupted. Standby A few minutes after the last key is pressed or at the end of the program the dishwasher will switch into Standby mode to save energy. The display and the indicators are turned off and only the U indicator lights. If refill salt and/or rinse aid or a fault are present in the display, the dishwasher will not switch to Standby mode. Selecting a program Choose your program according to the type of load and soiling. You can now select any additional options (see "Additional Options"). 29 Use Program Guide Progra m guide When to use Pre-rinse 1 Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. X 2 Program sequence Main wash X Interim rinse 1 X 2 Final rinse X Drying X Normal as required Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For temperature sensitive glassware and lightly soiled dishware, use 50% detergent recommended. X X X X X China & Crystal X X X X SaniWash To sanitize dishware, e. g. To rinse dishes when a complete program is not needed detergent is not recommended. X X X X X X X X X Rinse & Hold Usage: Electrical - 0. 01 - 1. 23 kwh Water - 1. 3 - 5. 3 gal (5 - 20 l) 30 Use At the end of a program ^ Open the door slightly to check whether the program has finished. The program has not yet finished as long as the program indicator is still flashing. Close the door again so that the program runs to the end. Turning off At the end of a program: ^ Open the door. The dishwasher continues to use electricity until turned off with the V button. To be safe, turn the water supply off if the dishwasher is unattended for an extended period of time, e. g. during vacation. In the "Express" program, the drying fan will run for a few minutes after the program is completed. You can now empty the dishwasher. Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. If you open the door fully after switching off, the dishes will cool much faster. Unloading the lower basket first will prevent water drops from the upper basket and cutlery tray (depending on model) from dropping onto dishes in the lower basket. tops rom steam, open the door after the the end of the program either fully (never ajar) or keep it closed until you are removing all the dishes. , To avoid damage to counter 31 Use Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed again, the program will continue from where it was interrupted. Changing a program If the detergent dispenser flap is already open, do not change the program. [. . . ] Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 55 Plumbing Waterproof system All Miele dishwashers have a safety valve located on the incoming water line and a sealed underside with a water sensor. If a fault occurs, the water intake is stopped and the drain pump is activated. Providing the dishwasher was installed correctly by a Miele technician, the waterproof system will protect you from water damage throughout the lifetime of the machine. Connection to the water supply , Installation, repairs and other work by unqualified persons could be dangerous. , Do not drink water from the dishwasher! [. . . ]