User manual MIELE DA 220-3

[. . . ] Operating and installation instructions Ventilation System DA 210-3 DA 220-3 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 853 490 Table of Contents IMPORTANT SAFETY INSTRUCTIONS Guide to the appliance DA 210-2 . 17 After Sales Service Installation instructions 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. The manufacturer cannot be held responsible for damages caused by improper use of the hood. [. . . ] The light button indicator will go out. Dimming the lighting The brightness of the lighting can be adjusted. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. ^ Press the light button again to turn off the lighting. 12 Operation Grease filter timer A timer monitors the hours of fan operation. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing , Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. 15 Cleaning and care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). ^ Clean the filters - by hand: use a scrub brush in warm water with a mild detergent. - in a dishwasher: place the filters in the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ To remove the grease filters press the locking clips in towards the middle of the filter. ^ After returning the grease filters, press the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the timer has reached its maximum, the grease filter button should be pressed for 6 seconds to reset the counter to zero. The grease filters should be cleaned every 3-4 weeks or whenever the grease filter timer indicator lights. A dirty filter is a fire hazard. 16 Cleaning and care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. [. . . ] ^ Tape the screws from above to prevent them from being pushed upwards when the nuts are tightened. 28 Installation ^ Screw the mounting plate through the ceiling and into the structural framing using 8 x 60 lag bolts and washers. Once tight, make sure that the mounting plate can safely support the weight of the hood. ^ Using at least two people, lift the hood and guide the spring clips through their respective slots in the flange at the top of the chimney. Make sure they click into place and that the hood is hanging securely from the spring clips before allowing them to carry the weight. 29 Installation ^ Bolt the flange firmly to the ceiling using the four M6 nuts. ^ Shorten the power cable as much as possible and attach it to the terminal block inside the chimney. [. . . ]