User manual MIELE DA 402

[. . . ] Operating and Installation Instructions Ventilation System DA 402 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 06 473 980 Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan . 18 After Sales Service Installation instructions Caring for the environment Installation accessories Plywood backing Electrical data Appliance dimensions Installation Installation instructions . 32 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. [. . . ] Press once = 5 minute delay (left indicator lights) Press twice = 15 minute delay (right indicator lights) To cancel the Delayed Shut Down feature press the button again. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was activated. The lighting however will remain on. ^ Press the On/Off button to turn the fan back on again. 12 Operation Turning the lighting on/off The overhead lighting can be turned on and off independently from the fan. Dimming the lighting The brightness of the lighting can be adjusted. The lighting will dim until the button is released. ^ Press the light button briefly to turn on the lighting. The light button indicator will go out. ^ If the button is pressed again, the lighting will brighten until the button is released. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing Warning: Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. 16 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). Cleaning the grease filters ^ - By hand: use a scrub brush in warm water with a mild detergent. - In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. Wash using the "Sani Wash" or "Normal Plus" programs. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visibly facing the cooking surface. Lower the filter 45°, 2, unhook it at the rear, 3, and take it out. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press and hold the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the grease filter timer has reached its maximum, press the grease filter button for 6 seconds to reset the counter to zero. The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. [. . . ] 26" (65 cm) is recommended for all installations to allow for optimum work space under the hood. Read the entire installation procedure and determine height (S) before beginning the installation. If the hood is fitted flush to the ceiling make sure that the remaining distance to the ceiling is not greater or less than appliance height (H). (720 - 1015 mm) To fit the chimney, the distance between the top of the chimney and the ceiling must be at least 7/8" (20 mm). [. . . ]