User manual MIELE CVA610

[. . . ] Operating instructions Coffee System CVA 610 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 61 3 IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed, including the following: Read all instructions before installation or use of the coffee system. Electrical safety Please read these instructions carefully to prevent accidents and machine damage. Any other use is not recommended by the manufacturer and could be dangerous. Improper use of the appliance can cause personal injury and material damage. [. . . ] ­ If the crema is very dark brown on one side, graduating almost to white on the other, the ground coffee is too fine. To adjust the grinder setting ^ Push the upper slide control to the left for finer grinding or to the right for coarser grinding. If the slide control will not move: ^ Close the machine and dispense a cup of coffee. Then try to move the slide control again. 32 Setting the coffee grinder Setting the quantity Both the flavor and crema of the coffee depend on the quantity of ground coffee used. The quality of the crema is also affected by the quantity: ­ If the crema is evenly colored but pale, increase the quantity setting. ­ If the crema is very dark brown on one side, graduating almost to white on the other, decrease the quantity setting. ^ Push the lower slide control to the left to grind less coffee or to the right to grind more coffee. To adjust the quantity setting: 33 Coffee system care Daily care At the end of each day, the coffee dispensers and the brew unit must be flushed clean. The components of the coffee system must be cleaned after each day of use to prevent mold and bacteria growth. ^ Hand wash with hot water and liquid dish soap: ­ water tank, ­ coffee and hot water dispensers, ­ steam nozzle, ­ waste unit, ­ drip sponge, ^ Press the Rinse/pre-warm button. Hot surfaces can cause burns. ^ Press ENTER and the display will change to: ^ Hot water will flow through and clean the brew unit and coffee dispensers. 34 Coffee system care Exterior ^ The exterior can be cleaned with hot water and liquid dish soap applied with a soft sponge. ^ Wipe dry using a soft cloth. Interior The interior can be cleaned with hot water and liquid dish soap. Wipe dry using a soft cloth. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Apply sparingly with even pressure. A funnel is situated on the inside of the door. Rinse the sponge after each day of use. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly with hot water and liquid soap. Wipe up any spills from descaling immediately! 35 Coffee system care Drip catch The drip catch has a red float that will rise when the catch is full. The catch should be cleaned when the float rises and at the end of each day to prevent spills and odors. ^ Take the drip catch out of the appliance. ^ Close the door. ^ Remove the metal grate and plastic tray from the drip catch and clean by hand with warm water and liquid dish soap. ^ Open the appliance door. 36 Coffee system care Waste unit Steam nozzle Clean the steam nozzle after every use as dried milk residues are difficult to clean. ^ Lift the waste unit up and out. ^ Clean the waste unit by hand with hot water and liquid dish soap and dry with a soft cloth. ^ Loosen the upper screw, a, and pull the sleeve of the steam nozzle down, b. ^ Clean the sleeve with warm water and liquid dish soap (or in the dishwasher) and dry. ^ Push the waste unit back into place, positioning it over the notches. [. . . ] Installation, repairs and other work by unqualified persons could be dangerous. Verify that the voltage, load and circuit rating information found on the data plate match the household electrical supply before installing the coffee system. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele's Technical Service Department. USA 1-800-999-1360 CDN 1-800-565-6435 WARNING: THIS APPLIANCE MUST BE GROUNDED Important The coffee system comes equipped with a 6 ft (1. 8 m) power cord with a NEMA 6-15P molded plug for connection to a 208-240 V, 15 A, 60 Hz power supply. 56 Installation Installation options The coffee system is designed to be built into cabinetry. 57 Installation The coffee system can be installed above another appliance but, there must be a solid, closed shelf between the base of the coffee machine and the top of the appliance below (The shelf is not necessary when installation is in combination with the Miele built-in plate warmer). 58 Installation A speciality display cabinet is also available from your dealer or Miele's Technical Service Department, as an installation option. [. . . ]