User manual MIELE CRYSTAL G 5175 SCVI

[. . . ] Operating Instructions Dishwasher G 5170 G 5175 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 58 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Keep these operating instructions in a safe place and pass them on to any future user. the voltage and frequency listed on the data plate correspond with the household electrical supply. disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. [. . . ] Also make certain your china and crystal are dishwasher safe. 30 Use Adding detergent ^ Press the latch on the detergent dispenser. The flap is always open at the end of a program. ^ Add detergent to the compartments and close the container flap. ^ Use one tab or add powder or gel detergent to compartment II and close the flap. ^ If a Pre-rinse is desired, and available for your chosen program, add 1 teaspoon (5 ml) of detergent to compartment I. Compartment I holds a maximum of 2 teaspoons (10 ml), compartment II holds a maximum of 3. 5 tablespoons (50 ml) of detergent. The horizontal marks in compartment II indicate the levels of approximately 1 ¼ and 2 tablespoons (20 and 30 ml) respectively. The marks indicate the approximate fill level in ml when the door is open in a horizontal position. 31 Use Turning on ^ Open the water supply, if it is closed. The U indicator and the indicator of the last set program light up. Starting a program ^ Start the program by closing the door. the water softening) may be interrupted. Standby A few minutes after the last key is pressed or at the end of the program the dishwasher will switch into Standby mode to save energy. The display and the indicators are turned off and only the U indicator lights. If refill salt and/or rinse aid or a fault are present in the display, the dishwasher will not switch to Standby mode. Selecting a program Choose your program according to the type of load and soiling. You can now select any additional options (see "Additional Options"). 32 Use Program guide When to use Pre-rinse 1 2 Program sequence Main Interim rinse Final Drying wash rinse 1 2 X X X X Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For temperature sensitive glassware and lightly soiled dishware, use 50% detergent recommended. party dishware or to remove salt traces from the wash cabinet after refilling salt, not suitable for detergent tabs. To rinse dishes when a complete program is not needed. X Normal as required X X X X China & Crystal X X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 33 Use At the end of a program ^ Open the door slightly to check whether the program has finished. The program has not yet finished as long as the program indicator is still flashing. Close the door again so that the program runs to the end. Turning off At the end of a program: ^ Open the door. The dishwasher continues to use electricity until turned off with the V button. To be safe, turn the water supply off if the dishwasher is unattended for an extended period of time, e. g. during vacation. In the "Express" program, the drying fan will run for a few minutes after the program is completed. You can now empty the dishwasher. Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. [. . . ] If there is any question concerning the proper electrical connection or grounding of this appliance to the power supply, please consult a licensed electrician or call Miele's Technical Service Department: U 1-800-999-1360 V 1-800-565-6435 Specifications The dishwasher comes equipped with a 4 ft (1. 2 m) power cord with a molded plug for connection to 120 V, 60 Hz, 15 A grounded receptacle. 55 Electrical connection Hardwired electrical connection It is possible to hardwire this appliance to an existing power cable. , Prior to making a hardwire , CAUTION: Before servicing, disconnect the power supply by either removing the fuse, shutting off the power main or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer cannot be held responsible. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This appliance must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. connection to the terminal, remove the power cord. [. . . ]