User manual MIDLAND PL-2215P

[. . . ] ProLine Series PL2215P / PL2245P Operating Instructions Table of Contents I. Exposure Compliance Requirements for Occupational Use Only. . . . . . . . . . . . . . . . . . . . . . Compatible PL2215P / PL2245P Accessories. 17 Licensing, Safety and Service Information. . . . Exposure Compliance Requirements for Occupational Use Only The . ederal Communications Commission (. CC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio . requency (R. ) electromagnetic energy emitted by . CC regulated equipment. [. . . ] Match the four grooves of the battery pack with the guides on the back of the radio. Slide the battery pack up along the back of the radio until the release latch locks. To remove the battery pack, push down on the release latch and slide the pack downward, and away from the radio. 9 VI. Getting Started, continued Installing the Antenna Screw the antenna into the connector on the top of the radio by holding the antenna at its base and turning it clockwise until seated. The antenna should never be used to carry your radio, or as a base to clip radio accessories. Misuse of the antenna can cause damage, and reduce your radios performance. Installing the Belt Clip We recommend that the belt clip is installed on the radio. It keeps the radio from coming in contact with hot surfaces, and away from your body if heat build-up occurs with excess transmissions. If a replacement is needed, use a screw designed to the exact specifications as the original, to prevent accidental contact with internal circuitry, or possible personal injury. Some of the glues components may crack the radio back panel, causing radio damage and possible personal injury. Installing the Speaker Microphone Jack Cover If you are not using an accessory, install the provided cover over the speaker microphone jack using the screw supplied. Getting Started, continued Attaching the Optional Speaker Microphone 1. Use the thumbscrew attachment on the speaker microphone to make connection to the radio. NOTE: The radio is not fully water resistant while the speaker microphone is attached. 11 VII. Radio Operation Power On / Transmit Power on the radio by turning the power / volume control clockwise out of detent. To check the radio volume, press and hold the monitor button then rotate the control to desired volume level. Use the channel switch to choose the desired channel. To avoid interrupting another user, make sure the channel is clear before you begin transmitting. To transmit, place the radio microphone approximately 2 (5 cm) from your mouth. Nuisance Delete During receiving a signal or scan delay time, if the monitor button is pressed, the current receiving channel is deleted in scan list and is no longer scanned. When the power is turned off and on, the deleted channel is restored to the scan list. 14 VIII. Radio . unctions, continued Busy Channel Lockout When the RX signal is being received, the radios transmitter is disabled. Marked Idle When used in conjunction with busy channel lockout, the transmitter is allowed to operate as long as valid RX tone is received. [. . . ] Apply the solution sparingly to avoid any moisture leaking into cracks crevices - NEVER submerge the radio. DO NOT use solvents or spirits for cleaning - they may permanently damage the radio. Clean the battery and accessory jack contacts with a lint-free cloth to remove dirt, grease or foreign materials. · · 19 XII. Software Copyrights The Topaz3 / Legacy products described in these operating instructions may include copyrighted Topaz3 / Legacy software programs stored in semiconductor memories or other media. [. . . ]