User manual MIDLAND ML3215

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference; (2) This device must accept any interference received including interference that may cause undesired operation. Press SELECT (hour option will begin flashing) Press until current hour is displayed. Pressto choose "ENGLISH", "ESPANOL" or "FRANCAIS" then press SELECT. You can program the WR-120 All Hazards Alert Weather Radio with up to 25 S. [. . . ] These codes are known as Federal Information Processing System (FIPS in the USA) or Canadian Location Coded (CLC in Canada). Warnings, watches and statements of weather and other area emergencies, about 80 different types, will activate the weather radio for only your programmed specific area. Message contains information pertaining to the period for which the alert is valid. The broadcast station can set the active time of the alert from 15 minutes up to 6 hours. When the designated time has passed, the weather radio display message and light will automatically reset to their normal appearance. Your WR-120 All Hazards Weather Alert Radio comes preprogrammed to receive weather and hazard alert transmissions for all S. Code programmed will be the only one the radio alerts to, even though multiple codes can be entered in alternate S. Note: While in MENU mode, if no buttons are pressed for 60 seconds, the radio will automatically exit MENU mode. When the DISPLAY alert type is chosen, only a text alert will scroll on the display. When the VOICE alert type is chosen, the alert tone will sound for 8 seconds, then you will hear the voice of the weather broadcast for 3 minutes. If your station is transmitting and you are not receiving the broadcasts, you may need an external antenna. NOTE: Metal structures are more difficult to receive reception in because metal interferes with the signal. You can find out when your local station broadcasts test signals by calling the NOAA National Weather Service Forecast Office (listed under "Weather" in the Federal Government section of the telephone book). During the weekly test signal, the local station will give a list of counties covered by their transmitter. The test signal allows everyone with weather radio receivers to verify the operation of their equipment. The following test signals may be sent during testing: required weekly test, required monthly test, system demo, and national periodic test. During a test, the yellow advisory LED will light up and the "Weekly Test" or "Monthly Test" message will be visible on the display. While disabled in the menu, the radio will not sound an audible alert tone to avoid giving the impression of an actual alarm. The visual response to the test is confirmation that your radio is working properly. MIDLAND Radio Corporation will repair or replace, at its option without charge, your WR-120 All Hazards Alert Weather Radio which fails due to a defect in material or workmanship within ONE YEAR following the initial consumer purchase. [. . . ] MIDLAND Radio Corporation will repair or replace, at its option without charge, your WR-120 All Hazards Alert Weather Radio which fails due to a defect in material or workmanship within ONE YEAR following the initial consumer purchase. This warranty does not include any antennas, which may be a part of or included with the warranted product, or the cost of labor for removal or re-installation of the product in a vehicle or other mounting. Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, along with a copy of the original sales receipt to Midland Radio Corporation at the address provided below. This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state. [. . . ]