User manual MICROTEK GNC M TIS1-TID1 0703

[. . . ] All rights reserved Microtek® is a registered trademarks of Microtek International, Inc. Macintosh® and Apple® are registered trademarks of Apple Computer, Inc. Adobe® and Acrobat® are registered trademarks of Adobe Systems Incorporated. All other products or name brands are trademarks of their respective holders. [. . . ] A Pan icon ( ) appears on the LCD screen next to the image magnification level. Use the 4-way arrow buttons to scroll through parts of a magnified image into view. Press the Shutter (OK) button again to disable the Pan feature. !! Using the Slide Show The Slide Show selection enables you to view your stored images by playing them back in sequence (if you have stored more than one image). You can run the Slide Show for a business presentation, family show, or other situation. To run a slide show: 1. Use the 4-way arrow buttons to select SLIDE SHOW. When selected, the OK?setting appears as well and is highlighted in red, allowing you to run a slide show. Press the Shutter (OK) button again to stop the slide show. !" Rotating Images If you take a picture while holding the camera vertically, this selection enables you to rotate the image to a horizontal position when you play it back later for viewing. A screen appears to allow you to rotate the image or to cancel. Before 5. Use the 4-way arrow button to select 90°, 180°, or 270°, then press the Shutter (OK) button. setting appears as well and is highlighted in red, allowing you to rotate an image. !# Playing Movies Playback mode also enables you to play movies that are stored in memory on the LCD screen. To play back movies, 1. If this is a movie, the first frame of the movie is shown on the LCD screen and comes with a Movie icon ( ). 3. The movie will be played while the Shutter button is pressed. Press the Shutter (OK) button again to stop movie playback. Pressing the Shutter (OK) button once more restarts playback. !$ Television Viewing This feature enables you to view your cameras movies and images on a TV monitor instead of the LCD screen. To view the cameras images and movies on a TV, you must first select the video output system. Use the 4-way arrow buttons to select VIDEO, then select NTSC or PAL. To view images on a TV set: 1. Connect one end of the Video cable to the cameras TVoutput connector. Connect the other end of the cable to the Video In jack of the TV set. NTSC: . or USA, Canada, Mexico, Taiwan, Korea, Japan, etc. The most recently recorded image appears on the TV monitor. !% Deleting Images Deleting Selected Image If you want to delete a stored image, you must first select the image you want to delete. A confirmation screen prompts you to confirm your decision to delete the selected image. The selected image is removed from memory and will no longer be available for viewing. Deleting All Images To delete all images: 1. Use the 4-way arrow buttons to select ERASE ALL. You can remove images from the internal camera memory, as well as from the SD card. This allows you to free up memory space in which to store future images. Deleting the Current Image If you are currently viewing an image and decide that you want to remove it: 1. A confirmation screen prompts you to confirm your decision to delete the current image. When selected, the OK? [. . . ] The camera does not operate in PC/ Web Cam mode. A: The DirectX driver is not installed. Version 8. 1 or later is recommended. A1: The Mode switch is set to the incorrect mode. Set the Mode switch to (Photo). $ A2: The camera is not connected to the computer. Make sure one end of the USB cable is connected to your computer and the other end to your cameras USB connector. [. . . ]