User manual MICROTEK GNC M LIGHTLID35CALIB 0999

[. . . ] fo r PC an d LightLid 35 Calibrator Overview This consolidated PC/Mac guide describes the function and operation of the LightLid 35 Calibrator for Windows and the LightLid 35 Calibrator for Macintosh. [. . . ] For Macintosh, locate the icon from your defined folder. ) Then follow the calibration instructions as shown in the LightLid 35 Calibrator window below (sample figure is from Windows, which is identical to that of the Macintosh except for the title bar). NOTE Before launching the calibration tool, be sure that ScanWizard 5 is already installed on your system and your scanner is powered up. For optimum results, place the adapter in such a way that the adapter's front edge is pressed against the front glass frame of scanner and is centered horizontally. Click "Calibrate" button to start calibration Copyright© 1999 Microtek International Inc. http://www. microtek. com I49-002669A, September 1999 How Often is Calibration Required? To achieve optimum quality image, the calibration process should be repeated under the following conditions: · · · · Whenever the scanned image is unsatisfactory. It is also a good idea to perform the calibration before a day-long scanning session. Troubleshooting If the calibration program encounters problem during execution of the "Calibrate" command, one of the following error messages will display. Be sure to uninstall ScanWizard 5 before reinstalling the driver when correcting the error. "Load library failed. Reinstall ScanWizard 5. "Could not find the scanner driver!" ScanWizard 5 missing. Reinstall ScanWizard 5. "Could not find a valid scanner!" Scanner is not connected to host, or with loose connectors, or has no power. "The scanner is not ready!" Scanner to host signal communication (or hand-shaking) error. Refresh ScanWizard 5. "Memory allocation error!" Insufficient RAM. [. . . ] Reinstall ScanWizard 5. "Could not get the scanner default attribute!" Fatal error. [. . . ]