User manual MICROTEK C580

[. . . ] However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or particular television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient the receiving antenna. Connect the equipment into an outlet on a circuit different from which the receiver is connected. The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ] Unplug this video monitor from the wall outlet and refer servicing under the following conditions: a. If the video monitor does not operate normally according to operating instructions. If the video monitor has been dropped or the cabinet has been damaged Note: This user's manual for this LCD monitor containing graphics and information is for reference purpose only , which is subject to change without notice 1 Installation 1. Connect the video cable from VGA connector and audio line from output of the computer to the monitor. Wait about 30 seconds to adjust the picture with the adjustment controls to obtain the most optimum picture. Note: Please do not press the panel heavily because the surface of LCD panel is soft. Control Key Pads on the Front Panel 1. 7. 8 Press the keypad to enter OSD menu or swap between icon and subitems in OSD menu. Left : Press button to activate the adjustment of volume when OSD is off. Right : Press button to activate the adjustment of brightness when OSD is off. Power Switch : Press the keypad to power on or off. 2 Layout of Cable & Connector on the Back Cover 1. Audio Line-in 4. AC In How to enter OSD Menu (1) Press Menu button and the OSD as shown will appear on the screen. (2) The OSD Menu contains 9 icons representing 9 functions for adjustment. pointing up or down. (4) Press menu key to make the hand (5) Press up and down key to select sub-item. (6) Press Auto to exit OSD Menu. 3 Position AUTO LEFT/RIGHT DOWN/UP Clock HORZ. TOTAL DOT DELAY RESET Light / Contrast LIGHT CONTRAST BLACK LEVEL RESET Color RED GREEN BLUE WARM NORM COLD Auto adjust the position, horizontal clock and dot delay. Vertical position, adjust the vertical display screen position . Horizontal total clock, adjust the Horizontal Size to match LCD size. Reset the screen position, clock, H total and dot delay Adjust Brightness of back light Adjust the screen Contrast. Reset the light, contrast and black level to the default settings RESET Screen Status OSD Utility OSD TIMER OSD HORIZONTAL OSD VERTICAL Language : Sound VOLUME Reset All EXECUTE Adjust the contrast of red on screen. Display signal input resolution and H, V frequency . Select the duration of no operation to exit OSD Menu. [. . . ] Make Sure the LCD monitor is turned off and never spray or pour any liquid directly onto the screen or case. If still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a clean, soft, lint-free cloth, and wipe the screen. 9 Trouble-Shooting If you are experiencing difficulties with your monitor, check the following table for possible solutions. The signal cable should be completely connected to the video card / computer. Check the pin assignments and signal timings of the monitor and your video card. [. . . ]