User manual MICROTEK ARTIXSCAN DI 6240S

[. . . ] Along the tracks of the two sides of the Document Feed Tray, slide the feed tray down until the supporters of the tray touch the bottom edge of the tracks. Tilt the Document Feed Tray backwards in the direction as the arrow shown to fully open the tray. Along the tracks of the two sides of the Document Feed Tray, slide the feed tray down until it locks in place. Open Output Tray and Paper Stabilizer Bring down the a) Document Output Tray and b) Paper Stabilizer from the top towards the direction as shown in the graph. [. . . ] Launch ScanWizard DI as a stand-alone program by clicking on the ScanWizard DI icon on the desktop. Click the Scan Setup button in the interface to activate the Scan Setup interface. In the Scan Setup interface, follow the steps below to specify your basic settings. A) Select ADF (Front Side), ADF (Back Side) or ADF (Duplex) in the Scan Source as your image input device. Select Auto Color Detection to scan the image in color or non-color based on the automatic judgement and detection of the system. €“ Select Complex to scan the image in color, grayscale or non-color based on the customization. D) Select a desired resolution in the Resolution for your image output resolution. Click the Preview button to perform a preliminary view of the entire image. Go to the “General” panel by clicking the General tab in the Settings window. A) If necessary, specify the image settings for the front or back side of documents separately by using the Sides of Material control when Scan Source is set as “ADF (Duplex)”. C) If necessary, check “Double Feed”, then select a suitable paper thickness for the ultrasonic double-feed detection in the Paper Type options menu to prevent multiple pages from being fed together while papers are fed through the ADF. D) If necessary, check “Auto Document Rotation” to ensure the scanned images in a readable orientation. When it is checked, you can select the preferred language used as an identification in the options menu. E) If necessary, check “Remove Blank Page” and “Remove Punch Hole” to enhance the quality of the scanned images. If necessary, go to the “Image Process” panel by clicking the Image Process tab in the Settings window. Click the OK button to close the Scan Setup interface and return to the Main interface of ScanWizard DI. In the Main interface, click the File Format menu button to select a file format for the scanned images. In the Main interface, click the File Name menu button to specify a file naming method for the scanned images. In the Main interface, select and click the Normal Scan button to start scanning. When done, the scanned images will be automatically saved into the folder defined in the File Location menu box. At the same time, the scanned images will be displayed in thumbnail sizes in the Thumbnail View window and labeled with the file name and file format specified earlier. Click the Open Folder button to locate the scanned images if you want to view. [. . . ] Next, locate and click the “Manuals” option when the software installer window appears on your screen. Missing Items If your package is missing items, please call the Microtek Customer Service Department. Drivers & Software Upgrades After you finish the installation of software, if you found that the installed drivers and software cannot run your product or your computer system properly later, please go to the Microtek Download Service site at ww7. For additional information about Microtek products, please visit our website at www. [. . . ]