User manual MIA MIA

[. . . ] In general, we recommend that you keep the appliance out of reach of children. When switched on, the appliance must never come in contact with the hair on your head, eyelashes, ribbons, etc. To prevent any danger of injury as well as to prevent blockage or damage to the appliance. General information on epilation All methods of hair removal at the root can lead to in-growing hair and irritation (e. [. . . ] The green charging light (5a) flashes to show that the epilator is being charged. When the battery is fully charged, the charging light shines permanently. When the red low-charge light (5b) flashes, reconnect the appliance to an electrical outlet via the special cord set to recharge. Maximum battery capacity will only be reached after several charging/discharging cycles. As a safety feature to avoid overheating, it may happen that the charging lights 13 After cooling down, the appliance will continue charging with the green charging light flashing. Wet usage The appliance can be used on wet skin, even under running water. Make sure that the skin is very moist in order to achieve optimum gliding conditions for the appliance. Additionally, you may apply some shower gel to the moist skin for results that will leave your skin beautifully soft and smooth after wet epilation. Always make sure that the epilation head (2) is provided with a cap. Always make sure that the epilation area between the massaging rollers is in contact with your skin. Guide the appliance in a slow, continuous movement without pressure against the hair growth, in the direction of the switch. As hair does not always grow in the same direction, also guide the appliance slightly diagonally or in different directions in order to achieve best results. A b c d e f g OptiTrim comb Shaver foil Trimmer Release buttons Trim/shave selector Cutter block Shaver head base Press the release buttons (d) to remove the shaver head (D1). Tap the bottom of the shaver head gently on a flat surface (not on the foil). However, do not clean the shaver foil with the brush as this may damage the foil. Cleaning with water Press the release buttons (d) to remove the shaver head. Rinse the shaver head and the cutter block separately under running water (D2). Leave the cutter block and the foil frame to dry separately before reattaching them. Keeping your shaver head attachment in top shape · The shaving parts need to be lubricated regularly every 3 months (E). If you clean the shaver head under running water, please lubricate it after every cleaning. Apply some light machine oil or vaseline to the shaver foil and the metal parts of the long hair trimmer. Then remove the shaver head and also apply a tiny amount of vaseline as shown in picture section (E). [. . . ] For UK only: This guarantee in no way affects your rights under statutory law. This warranty applies in all States and Territories of Australia and in New Zealand and is in addition to any mandatory statutory obligations imposed on Procter & Gamble Australia Pty. This express warranty does not purport to exclude, restrict or modify any such mandatory statutory obligations. This warranty only covers defects in the appliance resulting from faults in workmanship or materials. [. . . ]