User manual METRONIC VIDEO SENDER

[. . . ] It sends the audio-video signal from the sources to the sender located in a distant room. It gets the RF signal from the transmitter and sends it to the secondary TV through a provided scart lead. The 4 buttons on the top (SEC) allow to choose, from the main TV, which source is sent to the receiver. [. . . ] For example, a scart lead may run from the VCR to the SAT receiver, and from SAT receiver to TV. In that case, leave the first link between VCR and SAT, and plug only on the transmitter the scart from the SAT receiver. See the paragraph called «serial connection» for more details 3 - Connect your main TV to the transmitter thanks to the provided scart lead. 4 - Install the transmitter as high as possible, avoiding mirrors or metal shelves that stops the RF waves. 5 - Plug one of the AC/DC adapters to the rear of the transmitter. 4 0 208 994 11 81 6 - Put the channel selection switch on position «1» 7 - Push on the « « button of the transmitter, the red light turns on. 8 - Switch on your main TV and then switch on all the sources connected to the transmitter. 9 - By pressing each one of the 4 bottom buttons (PRI) of the provided remote control, check that you can see any of the connected sources. B Setting up receiver 10 - Link the receiver and the secondary TV with the provided scart lead 11 - Switch on the SEC TV and put it in AV mode. The screen should be black 12 - Plug the AC/DC adapter on mains and connect it to the receiver. 13 - Put the channel selection switch on position «1» 14 - Press the « « button on the receiver, the red light should turn on and the programme from the transmitter should appear on the secondary TV. If not, make sure that all the sources from the main TV are on, as well as the transmitter. 15 - By pressing each one of the 4-buttons remote control, check that you can select any source from the distant room. If the picture is not OK, try to move the receiver to a better location (a few inches may sometimes do the trick). In case of no other location is found suitable, try another channel on BOTH transmitter AND receiver. 0 208 994 11 81 5 3 C Installing the remote extender 16 - For each device that you want to control from the distant TV, search for the location of the infrared sensor. 17 - Plug the garland into the IR port of the receiver and find the path for the garland that will allow to put a bead in front of each device. [. . . ] · In case of multi scart TV, check that you selected the right AV input. · The remote extender · Check the position of the infrared mouse doesnt work. · The transmission range of remote extender is a little bit shorter than the range for the video. [. . . ]