User manual METO-FER ML 13

[. . . ] OPERATING MANUAL ® METO-FER AUTOMATION AG MINI LINEAR UNIT TYPE SERIES FROM 5-25 ML 13-. . . -0 ML 13-. . . -A 1. Utilization The mini linear unit ML 13 is able to execute linear movements in any position. [. . . ] 4. 1 INITIAL OPERATION Compressed Air Remove the safety caps from the air connections. In order to regulate the velocity of the movement, we recommend our one-way flow controls DV-M5 (see sheet 5. 021). Unused air connections must be covered with the M5 caps. 4. 2 Stroke Adjustment loosen security nut on the end screw adjust the required stroke with the end screw (Pos. 101) tighten security nut on the end screw 4. 3 Cushion Adjustment The basic adjustment of the cushions has to be optimized by the user upon his special requirements. The brake resistance can be changed by adjusting the length of the brake path. When using oil and elastomer cushions, it must be checked that the end stop is not made by the cushions. The cushions should show a remainder stroke of 0. 039" (1mm). 5. 5. 1 MAINTENANCE Introduction The mini linear unit does not require any special maintenance procedure. Never use any type of solvents in order to clean the unit. 5. 2 Air Supply The mini linear unit is equipped with oil-free seals and can be operated with dry and non-oiled compressed air. If oiled compressed air is used, we recommend: Airpress compound SAE 5 (Klueber Order No. 6. 1 REPAIR Introduction If the unit no longer meets the requirements (leakage, wear, etc. ) the defective parts must be replaced. 6. 2 Safety Precautions Before dismounting the unit, it is necessary to check that the compressed air supply is turned off. When repair work is done, only the original spare parts and lubrication must be used. 6. 3 Replacing the Seals Remove the end plate (Pos. 5) by loosening the set screw (Pos. 201). Lubricate the cylinder bore and piston rod with grease (see chapter 7. 2). [. . . ] Position *203 *204 205 *211 *212 *213 Seal Kit Repair Kit 7. 2 Lubrication Grease for seals Grease for spherical liners Staburag NBU 4 Atemp. 005 040) Part Number 025. 140. 0054 025. 140. 1010 045. 100. 0005 025. 100. 0405 015. 100. 0040 010. 100. 0040 Description Rod Seal Piston Seal Linear Ball Bushings O-Ring Washer Nut Amount 1 piece 1 piece 4 pieces 1 piece 1 piece 1 piece Order No. [. . . ]