User manual MEDION UNIVERSAL REMOTE CONTROL MD 81035 CODELIST

[. . . ] If an invalid code is entered, the LED will flash for three seconds before going out. Should the device not respond as you expect it to do, you can try to repeat the programming using another code. Select the code that makes your device respond correctly to any command available on your remote control!If you failed this way, then have another try with the search method described in the chapter "Automatic code search". Code search (manual search) To run a manual code search, proceed as follows: 1. [. . . ] Briefly press the desired mode key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). Press several times in succession (up to 350 times) the "POWER" or "PROG" (channel upwards) or "PLAY" (only for a VCR) key until the device to be controlled has been switched off or responds. In view of the extensive number of different code numbers, up to 350 different codes have already been pre-programmed per device type. It is possible that only the most common main functions will be available in individual cases. In case of some special device models, the procedure described may fail to be successful. ­ The Code search starts with the 3-digit number stored at the moment. Code search (automatic search) An automatic search allows you to find even codes of brands that are not stated in the code list. Point the remote control at the device you wish to control and press the CHAN+ key once briefly. If the device does not possess a channel function, then press the PLAY or POWER key instead of CHAN+. Each time a code is sent, the LED will light up. 3 Manual URC 4689 UK Apr05. fm Seite 4 Montag, 11. Should you fail to press the OK key in time, you can step by step return to the code to which the device has responded using the CHAN­ key. If you want the remote control only to send a new code every 3 seconds instead of every second, proceed as follows: Press and release CHAN+ (or PLAY or POWER) twice (see step 5). Briefly press the desired mode key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). Now press the key on the universal remote control which will learn the function (the LED will permanently light up). Press the key of your original remote control until the LED of the universal remote blinks once (each false programming will be indicated by blinking of the LED). Press the SET key to end the programming. Deleting commands under one mode key To delete all codes referring to a device selection key, proceed as follows: 1. Briefly press the desired mode key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). All learned commands entries under that mode are now cleared. Deleting all commands under all modes 1. All learned command entries are now cleared. 5 Manual URC 4689 UK Apr05. fm Seite 6 Montag, 11. April 2005 12:00 12 ALL OFF function You can switch off all pre-programmed devices simultaneously. The selected device will be switched off and the corresponding MODE key will light up. Press the ALL OFF key immediately once again and keep it pressed for approx. The remote control has to be pointed at the devices to be operated until the MODE key goes out. [. . . ] Press the ALL OFF key immediately once again and keep it pressed for approx. The remote control has to be pointed at the devices to be operated until the MODE key goes out. These devices will be switched ON with the ALL OFF function if they were turned OFF. Toggle function You can zap between 2 channels by pressing the P<P key. Press again P<P and the mode key of the device you wish to control. [. . . ]