User manual MEDION MD 82467 CODE LIST

[. . . ] Please read these instructions carefully before operating the remote control. Keep the instructions in a safe place for future reference or in case you need to pass them on to someone else. The device has a safety system that prevents the emission of dangerous laser rays escaping from the device during normal use. In order to avoid injury to the eyes, never interfere with or damage the unit's security system. [. . . ] When the device responds accordingly each time a key is pressed, press OK to save the code. If you want to know which code is saved on a particular mode key, simply press this key. After you have finished programming your remote control for your audio/video devices, the remote control will work in the common main functions just like the original remote control for the respective device. point your remote control at the desired device and press the relevant mode key. [For the universal functions ­ see Universal functions ("Punch Through") on page 29 ­ you do not need to press the mode key in advance. ] Activate the functions by pressing the corresponding function key on your universal remote control. The symbol for infrared transmission appears each time you press a key. Each time a key is pressed the display backlight switches on for between 10 and 60 seconds (to set this duration please read: "Backlight" on page 10). Please note: In certain circumstances, not every function of your original remote control may be directly available on the universal remote control. Especially for newer devices, it might be possible that the functions are stored to different keys than expected or may not even be available at all. In these cases you can use the learn function to transfer the functions of your original remote control to the desired keys of the universal remote control (see "Learn function" on page 24). After you program a device code, the universal remote control keys can have double functions (with the exception of the SETUP and MACRO keys). To use the second function, briefly press the SETUP key and then (within 15-20 seconds) press one of the secondary function or number keys. Try out which additional functions a key has for a particular device code. To enter the time after Use the arrows which the TV device should switch itself off automatically. press OK" The SUCCESS confirmation message appears along with the TV timer symbol "Zzz". Lay the universal remote control down so that it is pointing towards the device and is not obstructed. If a sleep-timer is on ("Zzz" appears in the display) TV SLEEP CLEAR appears in the display instead of TV SLEEP SET when you perform the steps described above. Switching to another programme); the bell symbol appears in the display. You can use the command timer to program a function that is to run automatically at a particular time within the next 24 hours. The command series can contain up to four commands, the first command must always be the selection of a mode key. The following keys are not available for the remaining three commands: the mode keys, the joystick (arrows and OK), MACRO, SETUP, EXIT. [. . . ] The universal functions (also called "Punch Through" functions) enable you to carry out certain functions on a different device type than the programmed one. If the remote control is in TV, SAT or cable mode (devices without playback function), the PLAY, STOP, PAUSE, FAST FORWARD/BACK, and in some cases RECORD keys will control a connected video recorder, DVD player or video recorder. This Punch Through control does not work if the programmed TV, SAT or cable code has its own video recorder function (for example in the case of a combined TV-video recorder device). When the universal remote control is controlling this type of device and the VOL ) (Mute) keys are pressed, the volume control is transferred to (Volume) or ( the TV. [. . . ]