User manual MEDION MD 82339 CODE LIST

[. . . ] : Press and hold for a few seconds to turn device off (the device can be turned on with any button except MODE: Press repeatedly to select operation mode. : When pressing this button, the control panel slides out electronically and the disc slot becomes visible. : Release control panel ) and decrease ( ) volume AS/PS: Press and hold for 2 more seconds: the radio will search for six stations and store them into the preset memory 1-6 : Opening the settings menu of the car radio 5. : USB connection : Tune up; track up; press and hold for fast forward : Pause and start playback with media EN-3 11. [. . . ] If the car radio shows a defect that cannot be remedied through switching off and back on, press the cartridge of a ballpoint pen or other sharp object in the RESET button opening. You do not need these explanatory notes when connecting the radio to your vehicle ISO plugs. Two ISO connectors with cables are supplied: Connecter with electric cables for ISO socket block A Connecter with loudspeaker cables for ISO socket block B The yellow memory back-up cable must be connected to the permanent plus. Otherwise the station memory will not work (see "Arrangement of the ISO block" on page 22). please refer to the amplifier operating instructions for the correct connections. Never connect the blue cable to the engine cable; this could damage the radio!If the vehicle only has front loudspeakers and the cables for the rear loudspeakers are not needed, you must professionally insulate the exposed ends of these cables. BLOCK B ­ speakers 1 2 3 4 right rear + right rear right front + right front BLOCK A ­ electricity supply 1 2 3 4 Left front + left front left rear + left rear - In some vehicle models, the standard arrangement of cables and in the ISO block A are switched at the factory. If this is the case with your vehicle, certain functions may be impaired: stations may not be stored properly, for example. To solve this, reverse the red cable (switched plus) and the yellow cable (permanent plus) in the ISO block. Do not switch on the radio for long periods of time when the motor is switched off. This could cause the car battery to discharge and the vehicle can no longer be started. This is set automatically by the RDS station and keeps running even when the radio is switched off. In one of the three band ranges FM1, FM2 or FM3, then press the key or to find stations in the VHF band ranges that are broadcasting an AF signal. The AF mode is switched on in the delivered condition, or after a reset. After the search function has found a station, press and hold one of the 16 station buttons for about two seconds. The radio will switch back into automatic search mode after a few seconds. The found stations are automatically stored on the station buttons 1-6. You can call up the stored stations for the current transmission areas. In addition to traditional music and voice services, they also broadcast additional information in the form of encrypted digital signals that can be displayed by the car radio. This information - like the station name or the title of the track currently being played - is shown in the display. If the station does not broadcast RDS signals, the frequency will appear instead of the station name. [. . . ] If you play back a VCD with PBC (playback control), you can also open the menu by pressing TITLE. For DVDs, enter the title ("T") and the chapter ("C" which contains the title. When your list is complete, use the arrow keys to move to PLAY and press ENTER to play back the titles. To choose the category you would like to Use the arrow keys select: TT (Title), CH (chapter), TRK (track), or (time). [. . . ]