User manual MEDION MD 81883 CODE LIST

[. . . ] Do not place objects that are filled with water, such as vases, on the appliance. Naked flames such as lit candles must not be placed on the appliances. The rubber feet on the appliances may leave marks on furniture surfaces. Place the devices on a suitable underlay if necessary. Helpline No. [. . . ] Remove the paper backing from the sticky surface of one of the three IR transmitters and stick the IR transmitter onto the audio/video source so that it is aligned with the infrared receiver on this appliance. 1 cm away from the infrared receiver: As the infrared extender has three IR transmitters, you can simultaneously operate more than one appliance remotely from the receiver. For example, you can use the video recorder as well as the DVD player in another room. Audio adapter If you want to connect the transmitter to a 3. 5mm audio jack on an audio source, use the audio adapter and connect it to the audio plugs (red/white) of the AV cinch cable. Mains adapter To supply the transmitter with power, connect one of the mains adapters supplied. Connect the appliance plug to the 7. 2V socket on the transmitter and connect the mains adapter to a 230 V ~ 50 Hz power outlet. Helpline No. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 15 Source 1 and source 2 You can now use the SOURCE 1/2 switch on the transmitter to choose which signal will be transmitted to the TV connected to the A/V output. The appliance on the DIN socket AV IN1 is "SOURCE 1", the appliance on the DIN socket AV IN2 is "SOURCE 2". Starting operation 1. Flip up the transmitter aerial and align it with the inside facing the receiver. Switch the source appliance on and press the transmitter's on/off switch for about 2 seconds. Use the channel switch at the bottom of the appliance to select a channel (A/B/C/D) to which the signal will be sent. Helpline No. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 16 Example of transmitter arrangements With one appliance The following diagram shows a typical arrangement with a satellite receiver and a TV on the transmitter side: Helpline No. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 17 Sample transmitter setup with two appliances The following diagram shows a typical arrangement with a satellite receiver, a TV and a DVD player on the transmitter side: Helpline No. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 18 Connecting the transmitter to a computer 8 You can also connect the transmitter to a computer in order to transmit computer output to a television, for example. It does not usually make sense to transmit computer output to a TV for running computer applications, since the TV's screen display is not usually good enough to display the higher resolution computer image. If you want to show videos or presentations, however, displaying them via the TV is highly recommended. The following requirements must be fulfilled: · Your computer has a video output that provides video images suitable for a TV. If all the settings are correct, the image from the PC will now be displayed on the TV. Limitation of liability for loss of data/consequential losses Backup: To avoid loss of data you should back up all data to external media (such as CD-R) each time you change your PC system. Functionality: The enormous differences between operating systems and graphics cards mean that we cannot guarantee the functionality described in this section ("Connecting the transmitter to a computer"). Consequential losses: When you connect the radio transmission system to your computer, you must take note of the operating instructions for your computer, the software used and additional components. We are not liable for damage or loss of data that were caused by incorrect or improper use. Helpline No. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 21 Connecting the receiver Setting up 1. Place the receiver on a flat, sturdy surface. 9 Connections for the receiver 1. Connect the receiver to the audio/video appliance that should receive the signals from the source. [. . . ] Choose a different channel. The remote control does not respond Point the remote control directly towards the receiver. Ireland 1-800-992 508 Web Support www. medion. co. uk Model Number: 81883 28 Cleaning 13 In order to clean the video transmitter wipe it with a suitable cloth, for example a fine, leather, microfibre or dust cloth. Never treat the surfaces with hard brushes, aggressive or corrosive liquids, strong cleaning materials or solvents such as paint thinners, oils, acids or similar. Disposal 14 Packaging The radio transmission system is packaged to protect it from transportation damage. Packaging is raw material and can be re-used or added to the recycling system. Device At the end of its life, ensure that the appliance is disposed of in an environmentally appropriate manner. [. . . ]