User manual MEADE ETX PE ADDENDUM

[. . . ] Installation Instructions LNTTM SmartFinderTM Lens For use with Meade ETX-PE Series Telescopes Introduction The ETX-PE Series telescope is shipped with the LNT module attached. [. . . ] Notice that the tongue has slid in over the small plastic molded post. Fig. A: Peel back film from just the "tongue" of the lens. 2. Insert the tongue into the SmartFinder slot. Angle the tongue towards the front of the LNT module as you slide it into place. D: Remove the rest of the protective film. Slot 4. Remove the remainder of the plastic film from the lens, but avoid touching the lens as you do so--you may scratch the lens or leave fingerprints. Fig. B: Insert tongue into LNT module slot. SmartFinder Addendum LNTTM SmartFinderTM Lens For use with Meade ETX-PE Series Telescopes Aligning SmartFinder In order for the SmartFinder to be useful, it must first be aligned with the main telescope, so that both the SmartFinder and the main telescope are pointing at precisely the same location. Point the main telescope at some well-defined distant (perhaps a mile away) land object, such as a telephone pole or sign. Center the object, as precisely as possible, in the SP 26mm eyepiece's field of view. Tighten the vertical and horizontal locks so that the tube cannot move and the object remains centered. [. . . ] Customer Service hours are 7:00 AM to 6:00 PM, Pacific Time, Monday through Friday. Part no. [. . . ]