User manual MCCULLOCH TRIMMAC 251 SST

[. . . ] Max speed of output axle, rpm 2 SAFETY RULES When using gardening appliances, basic safety precautions should always be followed to reduce the risk of fire and serious injury. Operator is responsible for following instructions and warnings on unit and in manual. Be thoroughly familiar with the controls and the proper use of the unit. Restrict the use of this unit to persons who read, understand, and follow instructions and warnings on unit and in manual. [. . . ] We recommend McCulloch® brand oil mixed at a ratio of 40:1 (2. 5%). A 40:1 ratio is obtained by mixing 5 liters of unleaded gasoline with 0, 125 liter of oil. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. WARNING: Remove fuel cap slowly Choke Lever Primer Bulb 1. Muffler Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. HOW TO STOP YOUR UNIT 9. S To stop the engine, move the ON/OFF switch to the OFF position. HOW TO START YOUR UNIT STARTING A COLD ENGINE (or a warm engine after running out of fuel) Starting Position WARNING: The trimmer head will turn while starting the engine. Pull starter rope sharply until engine runs, but no more than 5 pulls. Allow engine to run 15 seconds, then move the choke lever to the OFF CHOKE position. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE. Pull starter rope sharply until engine runs, but no more than 6 pulls. If the engine doesn't start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than 6 pulls. S For trimming or scalping, use less than full throttle to increase line life and decrease head wear, especially: S During light duty cutting. S Near objects around which the line canwrap such as small posts, trees or fence wire. TRIMMING - Hold the bottom of the trimmer head about 80 mm above the ground and at an angle. Other sizes and shapes of line will not advance properly and will result in improper cutting head function or can cause serious injury. Wire can break off during cutting and become a dangerous missile that can cause serious injury. CUTTING METHODS 80mm above ground SCALPING - The scalping technique removes unwanted vegetation. Hold the bottom of the trimmer head about 80 mm above the ground and at an angle. [. . . ] Engine will not accelerate, lacks power, or dies under a load. Engine smokes excessively. Engine runs hot. 9 DECLARATION OF CONFORMITY relating to 2000/14/EC EC Declaration of Conformity relating to 2000/14/EC We, Electrolux Home Products, Inc. , Texarkana, TX, 75501, USA, Tél. : +1 903 223 4100, declare under sole responsibility that the McCulloch model TrimMac 251 SST grass trimmer was assessed in accordance with Annex V of the DIRECTIVE and from serial numbers 2003-258N00001 and onwards, conforms to the provisions of the DIRECTIVE. The measured sound power is 102 dB and the guaranteed sound power is 112 dB. Bounds, Director Product Safety and Standards DECLARATION OF CONFORMITY relating to 98/37/EC EC Declaration of Conformity (Directive 98/37/EC, Annex II, A) (Only applies to Europe) We, Electrolux Home Products, Inc. , Texarkana, TX, 75501, USA, Tél. [. . . ]