User manual MCCULLOCH MT765

[. . . ] This modern outdoor power tool will provide many hours of useful service. This operator's manual provides you with easy-tounderstand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. [. . . ] Check the indexing teeth on the inner reel and outer spool for wear (Fig. For Use with Single Line ONLY Slotted Holes For Use with SplitLineTM or Single Line Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible (Fig. Wind the line in tight even layers in the direction indicated on the inner reel. NOTE: SplitLineTM can only be used with the inner reel with the slotted holes. NOTE: Always use the correct line length when installing trimming line on the unit. Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool (Fig. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel. Take approximately 20 feet (6 m) of new trimming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel (Fig. Pull the line through the inner reel so that the loop is as small as possible. Place your index finger between the two lines to stop the lines from overlapping. NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment. Insert one end of the line through one of the two holes in the inner reel (Fig. Pull the line through the inner reel until only about 4 inches is left out. Failure to maintain your air filter properly can result in poor performance or can cause permanent damage to your engine. NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment. Insert the ends of the line through the eyelets in the outer spool (Fig. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the spool. To avoid serious personal injury, always turn your unit off and allow it to cool before you clean or service it. NOTE: The blue choke lever must be in Position 2 to remove the air filter/ muffler cover. NOTE: Operating the unit without the air filter and air filter/muffler cover assembly will VOID the warranty. Place the air filter/muffler cover over the back of the carburetor and muffler. [. . . ] MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator's Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by MTD for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any MTD product that is used for rental or commercial purposes, or any other incomeproducing purpose. [. . . ]