User manual MCCULLOCH MOWCART 66

[. . . ] www. mcculloch. biz MOWCART 66 Operator's Manual / 96021000900 IMPORTANT: Read and follow all Safety Rules and Instructions before op er at ing this equipment. Patents Pending 532 43 67-90 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. WARNING: In order to prevent accidental starting when setting up, transporting, ad just ing or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. WARNING: Do not coast down a hill in neutral, you may lose control of the riding mower. WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. [. . . ] With engine running, turn ignition key counterclockwise to ROS "ON" position. Slowly move motion control lever to reverse (R) position to start movement. When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. ROS "ON" Position Engine "ON" Position (Normal Operating) REVERSE OPERATION SYSTEM (ROS) The engine in your riding mower has been shipped, from the factory, already filled with summer weight oil. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. " · For cold weather operation you should change oil for easier starting (See the oil viscosity chart in the Maintenance section of this manual). · To change engine oil, see the Maintenance section in this manual. BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL 028 2 8 11 OPERATION Fill fuel tank to bottom of filler neck. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Purchase fuel in quantities that can be used within 30 days to assure fuel freshness. CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. ADD GASOLINE · MOWING TIPS · Mower should be properly leveled for best mowing performance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. · Drive so that clippings are discharged onto the area that has already been cut. This will result in a more even distribution of clippings and more uniform cutting. TO START ENGINE When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. Sit on seat in operating position, depress clutch/brake pedal and set parking brake. Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. NOTE: If at high altitude (above 3000 feet) or in cold temperature (below 32°F) the fuel mixture may need to be adjusted for best performance. RECOIL STARTING SYSTEM This unit is equipped with an engine recoil starting system. Pull recoil cord to start engine. Gasoline Filler Cap · When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. [. . . ] ENGINE OIL Drain oil (with engine warm) and replace with clean engine oil. Turn ignition key to "START" position for a few seconds to distribute oil. Replace with new spark plug(s). MOWER OTHER BATTERY · Fully charge the battery for storage. · If battery is removed from riding mower for storage, do not store battery directly on concrete or damp surfaces. [. . . ]