User manual MCCULLOCH MCS2001

[. . . ] When using power equipment, basic precautions should always be followed to assure maximum safety and optimum performance. Read this manual before assembling and operating this chipper shredder. Failure to comply with instructions may result in electrical shock, burns, fire, or personal injury. DO NOT ABUSE POWER CORD - Never carry power equipment by cord or pull cord to disconnect from outlet. [. . . ] When using the chipper shredder, an extension cord of adequate wire size must be used for safety and to prevent loss of power and overheating. The extension cord must be specifically intended for outdoor use and marked "SJ" or "SJT" and with the suffix "WA". The operation of any tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before operating power tool, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. Never place hands into Top Hopper, Side Chute or Discharge Chute as serious injury will occur (Figure 2-1). Use of these personal safety items is highly recommended to reduce the risk of accidental injury (Figure 2-2). NOTE: Locate small bag of hardware containing two Allen hex screws, two large flat washers, two small flat washers and two split pins. Secure by inserting a split pin through the hole in the end of the axle, bend the ends over using pliers. Position the axle assembly on the inside of the support tube as shown in Figure 3-1B, aligning the hole in the axle with the hole in the support. Place a lock washer and small flat washer on the Allen hex screw and guide them up through the hole in support tube and into the hole in the axle. Assemble the other tube support to the other end of the axle in the same manner. Attach the second wheel to the axle using the same method as described in step 1. Place a 2x4 under bottom of motor to obtain correct angle to attach wheel kit. Using hardware (flat washers of lock washers, and 4 hex bolts attach support tubes to motor housing & tighten. A WARNING identifies a procedure which, if not undertaken or if improperly done, can result in a serious personal injury or damage to the unit and/or both. (WARRANTY SYMBOL) serves notice that unless instructions or procedures are followed, any damage will void the warranty and all repairs will be at owner's expense. Service other than user maintenance should be performed by a McCulloch Authorized Service Center. Damage or conditions caused by improper maintenance practices which render this product inoperable will void the manufacturer's warranty. Use caution when tightening set screws to avoid contact with sharp cutting blades. Screws Use of these personal safety items is highly recommended to reduce the risk of accidental injury. Support Tube Allen hex screw, small flat washer and lock washer 3-1A Tube Insert 3-2A V-Blade Flange Never place hands into Top Hopper, Side Chute or Discharge Chute as serious injury will occur. [. . . ] If Top Cover Assembly Knobs are not tight the motor will not start due to the motor lock out switch not being activated. Before attempting any maintenance switch the machine off and disconnect the power cord. Switch the machine off and disconnect the power cord ensuring all moving parts are completely stopped. â· Wear gloves when attempting any maintenance to the cutting blades. [. . . ]