User manual MCCULLOCH MC025

[. . . ] Veuillez ne pas retourner le produit au détaillant. 1-800-554-6723 Register your product online at: Registre su producto en línea en: Enregistrez votre produit en ligne à l'adresse : www. mccullochpower. com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. McCulloch 9335 Harris Corners Charlotte, NC 28269 McCulloch 850 Matheson Blvd. [. . . ] Activate the primer bulb by pressing it and allowing it to return to its original form. The START LEVER helps to supply fuel to the engine to aid in starting. Activate the starting system by moving the start lever to the START position. DO NOT squeeze the throttle trigger until the engine has started and runs. After the engine starts, allow the engine to warm-up 10-15 seconds, then fully squeeze the throttle trigger to deactivate the starting system. COUPLER The COUPLER enables optional attachments to be installed on the unit. Pour the entire contents of the 3. 2 ounce (95 ml) container of oil into 1 gallon (4 liters) of gasoline to achieve the proper fuel mixture. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. This will cause permanent engine damage and void the limited warranty. BEFORE STARTING ENGINE FUELING ENGINE when refueling. WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. WARNING: Remove fuel cap slowly To obtain the correct oil mix ratio, pour 3. 2 ounces of 2- cycle synthetic oil into one gallon of fresh gas. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3. 2 fluid ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded HELPFUL TIP FUEL REQUIREMENTS IMPORTANT This engine requires the use of minimum 87 octane [R+M]/2 clean gasoline. Use of alcohol blended fuels (called gasohol or using ethanol or methanol) can cause major engine performance and durability problems. 10 WARNING: Alternative fuels (not gasoline) such as E- (15% alcohol), E- (20% -15 -20 alcohol), E- (85% alcohol) are NOT classified -85 as gasoline and are NOT approved for use in 2-stroke gasoline engines. Use of alternative fuels will cause problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc. Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation. HOW TO STOP YOUR UNIT S Release the throttle trigger. Wait 5 seconds before attempting to restart unit to allow switch to reset. Primer Bulb Start Lever ON/STOP Switch Starter Handle 4. Allow unit to run for 10-15 seconds, then fully squeeze the throttle trigger to disengage the starting system. HOW TO START YOUR UNIT Avoid any contact with the muffler. Starting position WARNING: If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. Move the start lever to the START position. HELPFUL TIP Squeeze and hold the throttle trigger. Pull starter rope sharply while squeezing throttle trigger until engine runs. NOTE: Normally, the warm starting procedure can be used within 5-10 minutes after the unit is turned off. If the unit sits for more than 10 minutes without being ran, it will be necessary to start the unit by following the steps under STARTING A COLD ENGINE or following the starting instruction steps shown on the unit. STARTING A WARM ENGINE 1. STARTING A COLD ENGINE NOTE: DO NOT squeeze the throttle trigger STARTING A FLOODED ENGINE Flooded engines can be started by placing the start lever to the RUN position. [. . . ] OWNER'S WARRANTY RESPONSIBILITIES: As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. McCulloch recommends that you retain all receipts covering maintenance on your small off-road engine, but McCulloch cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should be aware that McCulloch may deny you warranty coverage if your small offroad engine or a part of it has failed due to 19 abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an McCulloch authorized repair center as soon as a problem exists. [. . . ]