User manual MCCULLOCH HT42-420

[. . . ] Before use, examine cable for damage, replace it if there are signs of damage or ageing. Do not use the Hedgetrimmer if the electric cables are damaged or worn. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. [. . . ] Remove the plug from the mains :before leaving the Hedgetrimmer unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your Hedgetrimmer until you are sure that the entire Hedgetrimmer is in a safe operating condition; if the Hedgetrimmer starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the Hedgetrimmer is in safe working condition. Be careful during adjustment of the Hedgetrimmer to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the Hedgetrimmer should be stored using the blade cover/storage holder provided. 3 CABLES IMPORTANT · Use only 1. 00mm2 size cable up to 30 metres length maximum. · YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. Mains Cables and Extension Cables are available from your local Electrolux Outdoor Products Approved Service Centre. Please contact your local Electrolux Outdoor Products Approved Service Centre for further information on the connectors and kits available. CONNECTORS IMPORTANT · Connectors are suitable for use with 2 core cable only. Under no circumstances should these connectors be used for earthed products. They are not waterproof and must not be left outside permanently nor should they be submerged or immersed in water. A slight downward tilt of the cutting blades in the direction of motion gives the best cutting results. Side Cutting When trimming the sides of the hedge, begin at the bottom and cut upwards (See Fig. This shape will expose more of the hedge, resulting in more uniformed growth. G H 5 Caring for your Hedgetrimmer J Cleaning (J) 1. Using a soft brush - remove debris from all air intakes and cutting blade. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts. K Lubricating the Cutting Blade For easier operation and longer life, lubricate the cutter blades before and after use. Visually inspect the Hedgetrimmer for any worn or damaged parts, contact your local Service Centre if any parts require replacement. L M N To store your Hedgetrimmer · The Hedgetrimmer blade cover/storage holder is provided with 2 hanging slots for storing the Hedgetrimmer on the wall. (See Pic L) · Ensure the blade cover/storage holder is fitted before storage. The use of 2 number 10 screws (40mm in length) and the appropriate wall fixing plugs is recommended 2. Fit screw ensuring enough length is available for secure location into hanging slot. · Your mains cable can be stored with the blade cover/storage holder fitted. (Pic M & N) · Store in a dry place where your Hedgetrimmer is protected from damage. 6 Fault Finding Hints Fails to Operate 1. Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. [. . . ] * This guarantee is additional to, and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Replacing worn or damaged blades * Failures as a result of not reporting an initial fault. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades, Electric Mains cable. [. . . ]