User manual MC CULLOCH M14597TC

[. . . ] M145-97TC Euro Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 33 41 43 56 92 95 We reserve the right to make changes without prior notice. € Never allow children or people unfamiliar with the instructions to use the lawnmower. € Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. € • • • Cutting tips Clear the lawn from stones and other objects which can be thrown away by the blades. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. € To continue mowing, move unit forward to ensure bagger is completely lowered and in proper operating position which will allow mower to operate. 51 5 To convert mower: (Converting to mulching or rear discharging will require the purchase of these accessories. Insert plug assembly through back plate and into the mower deck chute adaptor. € Retain the plug assembly by connecting the two straps into the holes provided on the bagger support arms. • Replace bagger or optional rear discharge deflector to allow mower to operate. € • • To rear discharging • Place deck into the high cut position. € Attach the chute by applying the two wingnuts to the flange of the chute. € Install the discharge deflector to the backplate by screwing the four (4) wing screws into the threaded inserts located in the backplate. € Insert the discharge chute into the opening in the backplate and onto the mower deck adaptor. € Attach the chute to the tractor by applying the two wingnuts to the flange of the chute. € • • Do not drive in terrain at an angle of more than max. 54 5 Switching off the engine Move the attachment clutch control to disengaged position. Lift up the cutting unit and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. [. . . ] 88 6 WASCHANLAGEN-ÖFFNUNG DER ABDECKUNG A B DECK WASHOUT PORT Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. NOTE: For models with drive train guarding, the washout port is located on the LH side guard just in front of the rear tire. € Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. [. . . ]