User manual MC CULLOCH M105-85F

[. . . ] M11577RB Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. Prezechowywanie Uskladnenie Tárolás 3 18 31 39 41 49 78 81 We reserve the right to make changes without prior notice. € Never allow children or people unfamiliar with the instructions to use the lawnmower. € Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/ disconnection lever in position “connection”. Your machine is also equipped with a system that will not allow mower to operate if the bagger or optional rear discharge deflector is not installed properly. Choose a driving speed which suits the terrain and required cutting results. Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. Backing up with the attachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. USING THE ROS • Depress clutch/brake pedal all the way down and hold. € With engine running, turn ignition key counterclockwise to ROS "ON" position. • Move gear shift lever to reverse (R) position and slowly release clutch/brake pedal to start movement. € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. € • • • Cutting tips Clear the lawn from stones and other objects which can be thrown away by the blades. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or increasing the motor speed, without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. € • • Do not drive in terrain at an angle of more than max. 47 5 Switching off the engine Move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. [. . . ] € Move the tractor’s attachment clutch control to the “DISENGAGED” position. B DECK WASHOUT PORT Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. € Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. [. . . ]