User manual MC CULLOCH CS450 ELITE

[. . . ] the machine’s emission is specified in chapter Technical data and on label. Both of the operator′s hands must be used to operate the chain saw. Other symbols/decals on the machine refer to special certification requirements for certain markets. Symbols in the operator’s manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. [. . . ] The capacities of the chain oil tank and fuel tank are carefully matched. You should therefore always fill the chain oil tank and fuel tank at the same time. Never use a machine with visible damage to the spark plug guard and ignition cable. Transport and storage Always store the chain saw and fuel so that there is no risk of leakages or fumes coming into contact with sparks or naked flames from electrical equipment, electric motors, relays/switches, boilers and the like. For longer periods of storage or for transport of the chain saw, the fuel and chain oil tanks should be emptied. Ask where you can dispose of waste fuel and chain oil at your local petrol station. The guide bar cover must always be fitted to the cutting attachment when the machine is being transported or in storage, in order to prevent accident contact with the sharp chain. Even a non-moving chain can cause serious cuts to yourself or persons you bump into with an exposed chain. € • • • • Long-term storage Empty the fuel/oil tanks in a well ventilated area. Ensure the machine is cleaned and that a complete service is carried out before long-term storage. Be aware of the risks of fire, explosion and those associated with inhalation. However the movement of the start/stop switch will have engaged a high idle, making warm starting easier. Pull the starter handle, 6: Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. (22) Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the engine fires. Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Make sure you have a secure footing and that the chain cannot touch anything. Starting The chain brake must be engaged when the chain saw is started. (20) Cold engine CS 410 Elite Start position, 1: Set the start/stop switch in the choke position by pulling the red control outward - upward. (21) Air purge, 2: Press the air purge diaphragm repeatedly until fuel fills the diaphragm (at least 6 times). Hold the chain saw on the ground by placing your right foot through the rear handle. [. . . ] Make sure that the chain catcher is undamaged, and replace it if necessary. Check the saw chain with regard to visible cracks in the rivets and links, whether the saw chain is stiff or whether the rivets and links are abnormally worn. Check that there are no fuel leaks from the engine, tank or fuel lines. 28 – English TECHNICAL DATA Technical data CS 410 Elite Engine Cylinder displacement, cm3 Cylinder bore, mm Stroke, mm Idle speed, rpm Power, kW Ignition system Spark plug Electrode gap, mm Fuel and lubrication system Fuel tank capacity, litre Oil pump capacity at 9, 000 rpm, ml/min Oil tank capacity, litre Type of oil pump Weight Chain saw without bar or chain, empty tanks, kg Noise emissions (see note 1) Sound power level, measured dB(A) Sound power level, guaranteed LWA dB(A) Sound levels (see note 2) Equivalent sound pressure level at the operator’s ear, 103 dB(A) Equivalent vibration levels, a hveq (see note 3) Front handle, m/s2 Rear handle, m/s2 Chain/bar Standard bar length, inch/cm Recommended bar lengths, inch/cm Usable cutting length, inch/cm Pitch, inch/mm Thickness of drive links, inch/mm Type of drive sprocket/number of teeth Chain speed at max. [. . . ]