User manual MAYTAG VARA760S

[. . . ] Use & Care Guide Dishwasher MAYTAG MSE 760 FARS Quick Guide 1. There is no need to rinse thanks to the Super Cleaning SystemTM. 2. Dispensing dishwasher detergent The detergent compartment has a small compartment for pre-wash and one for main wash. 3. Select program and press start For washing normally soiled mixed loads use the Normal wash program normal temperature and normal drying . [. . . ] Machines with indicator on the panel When the rinse aid has run out and more is needed, the rinse aid symbol on the panel lights up*. Turn and lift up the cover of the rinse aid compartment to the right of the dispenser. This is where you top up and set the amount of rinse aid to be dispensed in each wash. Do not forget to close the cover. Select dosage The dispenser is usually set at 1= soft water. However, depending on the water hardness, it may be necessary to change the dosage. When the water hardness exceeds 10-12 odH you should use rinse aid with citric acid (acid rinse aid) if the machine does not have a water softening filter. If the machine has a water softening filter, dispense as for soft water. If your water is particularly soft, you can dilute the rinse aid (1 part rinse aid, 1 part water). Too much rinse aid can cause streaks on the dishes, while too little can result in water stains. *NB! After filling there may be a short delay before the signal light goes out. Machines with refill indicator There is a refill indicator in the middle of the dispenser (see picture). If the refill indicator is totally black, there is sufficient rinse aid. However, if the indicator has a more transparent appearance, you need to top up with rinse aid (see above). Open Refill indicator Closed Cover for rinse aid Open by turning and lifting the cover! 20 Salt Pour in salt (applies to dishwashers with water softeners) Before using a dishwasher with a water softening filter, you must fill the salt compartment with salt. It is best to fill with salt when you are about to do a wash, as the dishwasher needs to be rinsed out immediately after filling. Place the funnel, which is supplied with the dishwasher, into the compartment's filler hole. Wipe away excess salt so that the cover can be properly screwed into place. Run a Normal wash program so that any salt in the machine is rinsed away. When the salt runs out, the salt symbol on the display* lights up (this function is not available on all machines). The indicator is not working If the indicator is not working, this may be because the float, which is positioned under the cover, has become stuck in salt residue. The float can be reached through the green arm located under the cover of the salt compartment. Models without a salt symbol in the display show green in the salt compartment cover when there is sufficient salt. Cover for the salt compartment *NB! After filling, there may be a short delay before the signal light goes out. CAUTION! Never pour dishwasher detergent into the salt compartment. It will destroy the water softener! 21 Settings Reprogramming Some of the machine's functions can be reprogrammed. You get into the machine's change program using the machine's ordinary buttons as per the instructions below. [. . . ] Start by measuring the height from the floor to the underside of the work surface. After the steel feet have been adjusted, screw down the two rubber feet tightly against the floor. Start by measuring the height from the floor to the underside of the work surface. Tilt the dishwasher forward a fraction and roughly adjust the rear foot by screwing the set screw at the front clockwise to raise or anti-clockwise to lower (illustrated below). [. . . ]